How do you take out the inisde piece of a washer machine

do you mean the fuel pump relay ? it is located under hood just in front of driver sides power brake booster inisde the engine bay fuse panel , legend inisde cover marks it

Thank you for your inquiry, David Castro!

I understand that your Frigidaire washer is not working after the lid piece became broken. If the lid piece is not latching properly inside of the door latch then your washer is not registering the door is closed and will not start. You may need to have that piece replaced I would recommend having any electrical component replaced by an authorized technician. I hope this is helpful. -Matt

Loctite sounds the order of the day. Don't overtighten once the thread lock is in place and allow to cure before using machine.

you will need a small pipe cuter and a compression fitting that fits whatever size line you have. may also need an extra piece of line if the line is broken in more that a few spots or more than an inch or 2 apart. just cut out the broken section and slide the compression fitting ends onto each side of the line with the ring inisde toward the cut. then connect bothe ends to the center section of the fitting, pushing the lines together as you tighten it. then just fill your transmission to the proper fluid level and you should be good to go.

on the front panel under the lid/top piece are two clips use a screw driver to push trawards machine and it will bring front panel towards you and unhinge piece wala! all exposed

Contact Mieleusa at (800) 999-1360.

Bought a new lid switch and replaced it.

Depending on your washing machine model, the drum and motor are connected by 2 plastice yellow circular pieces, with a black rubber washer in the middle with holes where the pegs or rods go into. The 2 plastic circular pieces have 3 pegs or rods if you will, that connect to the black rubber washer via 3 holes. Sometimes, one or both of the 2 plastic circular piece pegs get broken off or the rubber washer cracks and breaks apart, so that the motor will not turn the drum. If thats the case, you can purchase the 2 circular pieces and black washer piece as a set.

Replace the knob...The teeth on the back of it have broken.

Do not remove that piece. It is needed.