How to clean pump fillter - Maytag Neptune MAH5500B Front Load Washer

Check out the drain pump

You might want to check this videos.

if no codes can still a few different problems 1-air fillter needs replacement-2- throttle body dirty clean if needed 3-tune up-4-egr needs cleaning 5-fuel filter clogging-6-fuel pump restriction malfunction 7-catylic conv clogging restriction

Check the rear end oil level. Failing that try cleaning the hydraulic oil fillter.

Remove the kickstrip, front of the appliance. Unscrew the pump filter by rotating it anti-clockwise, A little water may leak from the pump: this is perfectly normal. Clean the interior thoroughly, removing any visible debris. Refit by screwing the filter into place.

you will have to clean the fuel injectors and check fuel pressure, maybe the pump is going bad, dont let the fuel pump run without gas, some way gassoline works on the pump as cooling too, and if running dry then it will **** air and burn the pump,

Have you checked the fuel pressure? The fuel pump may be going out.

If you are putting fuel on to th fillter and it fires it sounds like the choke is not working right. Take of the air fillter and look to see if the butterfly is fully shut when pulled on. If it is a primmer pump look in to see if there is any fuel comming up when pumped if they are both working then try putting fuel into the plug hole and see if it fires if it does then it is a fuel problemTake off the carb again know you said it is clean but remove the main jet valve in the centre of the carb and clean it every hole blew out and 100% spot less rebuild carb and refit to mower hopefully that should short you outl davidson lawn mower tech

The filter is located behind the silver plate at the back of the machine at the bottom. Four screws hold it on. The filter is inside the big black rubber hose attached between the pump and the main drum. Remove the plastic clip holding it to the pump unit and then the metal cir clip holding it to the main drum. In side is a white molded cone and a big white ball which floats in side. You will find a lot of junk here, clean out. To refit put white cone back inside just as you found it, at the bottom, fit ball back into the cone. Attach to the bottom to the drum and re-fasten the cir clip. Finally reconnect the gator to the pump unit and tighten the plastic clip. Would be good to check out the pump too.

hello,good day,try to clean your engine breather,if ok,lift up your deep stick,while your engine is running,then observe if there is a huge volume of pressure,if yes,perform engine compression test,to evaluate your engine condition,ty