What corrective action for e47 code? - Washing Machines

Hi Adrian.
this is all i can find,
Bosch Washing Machine E47 Error - Heat Sink on Motor PCB Fault

Description:

Heat sink on the motor control module is broken.

Action To Take:

1. Replace motor control module.
2. or go to this link it will give you all the codes.
3. https://appliancefault.com.au/faults/washing-machine-faults/bosch-washing-machine-fault-codes/

Hey Ervin, thanks for your inquiry!
From the information you have provided your Frigidaire washer is displaying an error code of "E47". An "E47" error code means that the board thinks the door circuit is open in spin. This could be potential issue with the door lock or main control board. A reset could help correct this issue and to perform a reset you would need to disconnect power from it for at least ten minutes. We hope this information is helpful to some degree. -Matt

Good Afternoon Friend,

I understand you are receiving an E47 when the spin cycle is supposed to start, on your Frigidaire Affinity washer, model# ATF7000E. The E47 code states that the control board of you appliance thinks that the door is open. This could also be a false error code. I suggest resetting your washer, by either unplugging it or shutting the power of at your home's circuit breaker, for 3-5 minutes. Once power is restored, start any cycle. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if your appliances status has changed successfully. Hope this is helpful.

-Best Regards-
WP

That code is for a bad lock assembly. Here is the part you will need to order. Here is a video to show you how to replace it.

See other post.

It's the main control board that needs replacing. Here is a link to the part.

The E47 error code is usually an indication of a failed door lock/latch. To verify this, you will need to ohm out the PTC on the door lock. If the door lock does not ohm out correctly, then it will need to be replaced.

How to test the door latch on your washer

go to this website "http://www.llamma.com/xbox360/repair/Xbox-360-error-codes.htm" and read through the page and try find your hidden error code it will be more specific with your problem also that type of error has been added to microsofts warranty plan so you may be able to get it under warranty

E47 and E48 are door lock error codes, also check the wire harness connections too.

e47 i believe is a door lock issue, although its locking shut there are multiple switches in the lock mechanism