Question about Mitsubishi WD-62525 62" Rear Projection HDTV

2 Answers

Mitsubishi WD-62525 yellow blinking status light

I replaced the bulb because it went out and then the yellow blinking status light keeps blinking and wont stop. I tried resetting and unplugging the tv 3 times but it wont turn on.

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.
    Corporal:

    An expert that has over 10 points.
    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Check that the lamp door is closed all the way. There is a saftey switch that closes from the door being on all the way. If not the status light will keep blinking. There is also a switch on the air filter door.

Posted on Jul 16, 2009

  • Gus Vazquez
    Gus Vazquez Dec 24, 2013

    Outstanding. I checked it while on this particular page/site and it turned out to be precisely that. Despite the fact that my girlfriend tried to tell me that the door might have a sensor which didn't allow the light to go off and the tv to go on, I didn't listen and chose to check online. Now I have to apologize and give the due credit, along with this wonderful site and solution. Thank you very much....

×

Ad
Janice Ward
  • Level 1:

    An expert who has achieved level 1.
    New Friend:

    An expert that has 1 follower.
    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 1 Answer

Where is the air filter door at

Posted on Mar 21, 2014

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

6ya.com

Instant Repair Help over the Phone

6ya.com

Save Time & Money by instantly connecting to...

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WD-62525 went dead. Can a burned out lamp cause this?
No, a burned lamp would cause the power source of the tv to go in reduced mode and that would be clearly identifiable by the blinking lights on the status and lamp indicators.
If the tv is dead (no lights whatsoever)it means that the power source has failed completely - this is a big defect, that must be investigated by a pro: the origin of the failure must be found and the faulty part replaced replaced or any new part you just put in blindly will be instantly fried. At least the power source board will have to be replaced and that will cost you around $250.

Jan 03, 2011 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

I have a yellow blinking light after replacing light bulb
Either the lamp door isnt secured properly or the vent cover is open.

Oct 03, 2010 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

Timer light blinking fast and is green, Tv will not turn on even after a reset, bulb is good
First mistake was buying Mitsubishi Model WD-62525
The DM capacitors need replacement contact a local Mitsubishi Model WD-62525repair center.

Jan 23, 2010 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

I have a WD-62525 TV and I was getting a message
The lamp cover isnt secured properly that what causes the staus light to blink yellow.

Dec 30, 2009 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

WD-62525, continous amber lamp light. No picture. Lamp is good.
Hello:

Make sure u replace the lamp cover as the safety switch need to be closed to make the set work. If new lamp did not repair your problem , then it may well be the Ballast Board, Sometimes call the Lamp Driver.

Nov 28, 2009 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

Status light is blinking yellow...???
If there is no picture it is the lamp.

Nov 20, 2009 | Mitsubishi WD-62525 62" Rear Projection...

4 Answers

Mitsubishi WD-62525 timer light keeps flashing after lamp replace
There is a tiny reset button to the left of the timer light. Press with a pin or something small, wait 60 seconds. Viola!

Dec 29, 2008 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

How to reset "lamp status" for Mitsubishi wd62725
https://www.mitsubishi-tv.com/asset/file/owners_guide/WD-52525.pdf
Page 11 talks about using a paper clip to hit the recessed small reset button. try this

Dec 03, 2017 | Mitsubishi WD-62525 62" Rear Projection...

2 Answers

TV was working earlier, today came home no green power light no nothing
I looked up the manual online - after you replace the bulb, you need to reset the bulb life timer. Using the TV remote push the menu button, SETUP menu, select the lamp reminder option to reset the hours to zero. That might help the status indicators.

Sep 04, 2008 | Mitsubishi WD-62525 62" Rear Projection...

1 Answer

Mitsubishi 62" dlp wd-62525
The lamp is either defective, not connected properly to the wiring or plugs (careful alignment required on the two connections), wrong type bulb, or the front panel is not replaced properly to trigger the panel sense switch (lower right side of panel)

Sep 02, 2008 | Mitsubishi WD-62525 62" Rear Projection...

Not finding what you are looking for?

View Most Popular

WD-62525 62" Rear Projection HDTV

  • Televison & Video

Related Question

WD-62525 went dead. Can a burned out lamp cause this?

  • Mitsubishi WD-62525 62" Rear Projection HDTV

Open Questions:

0 Answers

capacitor locations on 1080p

Jul 10, 2014 | Mitsubishi WD-62525 62" Rear Projection...

0 Answers

where is reset button for thr mktubisushi tv,

Jul 01, 2014 | Mitsubishi WD-62525 62" Rear Projection...

0 Answers

green light on mitsubishi WD-65736 keeps blinking

Jun 24, 2014 | Mitsubishi WD-62525 62" Rear Projection...

0 Answers

How do I get error code

Jun 20, 2014 | Mitsubishi WD-62525 62" Rear Projection...

See all Mitsubishi WD-62525 62" Rear Projection HDTV Questions

Related Topics

Mitsubishi WD-62525 62" Rear Projection HDTV Logo

4,401 people viewed this question

Ask a Question

Usually answered in minutes!

Popular Questions

Mitsubishi WD-52525 52" Rear...

Mitsubishi WD-65733 65" HDTV

Mitsubishi WD-65C9 65" DLP HDTV

Mitsubishi Diamond WD-65831 65"...

Mitsubishi WD-52531 Television

Check Out the Latest HD Televisions Report
Check Out the Latest HD Televisions Report

View all Fixya Reports

Top Mitsubishi Televison & Video Experts

matt martin
matt martin

Level 3 Expert

1257 Answers

The Knight
The Knight

Level 3 Expert

76186 Answers

Ekse

Level 3 Expert

13434 Answers

Are you a Mitsubishi Televison and Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

PDF Manual
. WD-62525 62" Rear Projection HDTV...

WD-62525 62" Rear...

Loading...