Where can I purchase a European compatible power adapter for a Yamaha MG82CX mixer?

HQRP AC Adapter / Power Supply for Yamaha PSR ... - Fixya

www.fixya.com/search/...hqrp_ac_adapter_power_supply_yamaha.../60...

HQRP AC Adapter / Power Supply for Yamaha PSR-280 / PSR280 / PSR-290 / PSR290 Keyboards Replacement plus HQRP Coaster, 600 related issues. ... is there an internal battery to protect memory and if so, do i need to replace it? yes there ...HQRP AC Adapter / Power Supply for Yamaha DGX-620 / DGX620 / DGX- ...

HQRP AC Adapter / Power Supply for Yamaha PSR ... - Fixya

www.fixya.com/...hqrp_ac_adapter_power_supply_yamaha_psr/adapter

HQRP AC Adapter / Power Supply for Yamaha PSR-280 / PSR280 / PSR-290 / PSR290 Keyboards Replacement plus HQRP Coaster, adapter related ... need a new one, you could try to get a replacement from casio or try to get an ... It MAY appear to operate on DC BUT it can't generate the +/- voltages internally for sound .

Musical Instruments - Keyboard Accessories on Pinterest ...

https://www.pinterest.com/.../musical-instruments-keyboard-accessories/
HQRP AC Adapter / Power Supply compatible with Fulltone CATALYST / CHORALFLANGE Guitar Effects pedals Replacement plus HQRP Coaster by HQRP. $7.91. ... The MS-90 is a column monitor stand that features three internal channels - .... Yamaha SK88 Survival Kit for 88-Key YPG Series Keyboards by Yamaha.

A little vague, there, Chuck...
We have no idea if you even know how to plug the thing in... an no, it's not obvious because some people don't. Describe your connections and a little more about the problem.

Couplers and adapters available at any Radio Shack

If your mic can "hear" the beat, it will record it as well with a reverberation that will NOT be pleasing. Maybe you can use headphones to avoid that.

there is a main output, conect it to the aux in line or to the microphone line.good musics

Print your own from:

http://www2.yamaha.co.jp/manual/pdf/pa/english/mixers/mg82cx_en_om.pdf

Check the power adapter. It is a 38 volt AC centertapped unit with 0.62 amp rating. Verify that you get 38 volts AC between two of the pins and 19 volts AC between any other pair of pins with an AC voltmeter.

Check that the connector is seated. These can sometimes seem to be seated but not fully in place.

If trim controls or gains are set near maximum, HISS is normal as electronics generates a thermal type noise.

If gains are set in normal operating area, the noise SHOULD be minimal.

Other sources of interference like nearby radio transmitters, welders, arc lights, etc. can create noise.

Start with ALL gains turned down and find which if any cause the noise to be unacceptable.

MAKE SURE all power to this and ALL the other connected equipment come from a single receptacle to avoid ground loops.

sorry ...you haven't enough channels to mix all the kit ... you will have to run a stereo pair from the td8 to mg82 and mix it from the td8

Both stereo and mono jacks will work fine on the inputs, any guitar or mic lead will work a treat.

You can use stereo jacks for the outputs too, but to keep it simple just use a mono jack in the L out and a mono jack in the R out.