In my Minolta EP3000, coming white lines while copying

When was the last time the drum and developer where replaced and drum cartridge was clean along with transfer and sep assy??

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Watch these 2 Videos to clear

http://www.youtube.com/watch?v=ftWn6yoZ_Kc

The Fix http://www.youtube.com/watch?v=X-EpEMww1RA

Sir,
To clear this code requires you to gain access to the System reset. Open front door locate a small panel with one screw to release it in side will find two small black buttons find service and let machine reset if the code persists then your fusers is gone, the EP3000 is a legacy equipment may find a problem in locating spare parts if the thermistor, thermosat or fuser lamp is shot. Ensure machine is on when you attempt above.

has the optics been cleaned all the mirrors below the big glass how about the drum and developer has it been replaced?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

service or admin?

Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/normanj_7893313f0751935f

Minolta ep3000 Cspro error code c0000 is plz sloved it

Clean the optical parts:mirrors,lens and the charge and transfer/sepaRATOR CORONAS.

try to clean the all mirror

if not

replace the drum

Toner ctg. failure to rotate - try re -inserting

M1= main motor

1. Does the transport motor (M1) operate during power up?
NO, Ensure the connection of the connector (PJ21A) is secure.
2. Replace the transport motor.
YES, Check if there is excessive load on any of the rollers,gears,etc.
3. Replace PWB-A.