Question about Stihl Saws

1 Answer

Stihl ts 510 rope kick back really hard ? - Stihl Saws

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Stihl Master
  • 1,807 Answers

Does it start and run.? Is this just a recoil issue.? Do you use the decompression button on start up.?

Posted on May 28, 2016

Ad

1 Suggested Answer

6ya6ya

6ya staff

  • 2 Answers

SOURCE:

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I cure kickback when starting a Stihl 044 chain saw , as soon as you pull the starter cord it snatches it out of your hand it really hurts.


pull rope just pass compression piston top dead center release rope let it rewind fully .then pull rope quick and firm.

Oct 10, 2017 | Stihl Garden

1 Answer

I have the older model which has the 3 bolt ignition coil. If I replace the coil, does the new ignition coil have to be 3 bolt as well? the 3 bolt replacement coils are so much more expensive


Coils are usually engine specific, the number of bolts does not determine whether or not it will work. If you really want your chainsaw to work correctly - buy the right part. It's a cheaper than a new one! Using the model number you supplied, I found them for under $50, which is about the value of an old 050 Stihl -wow, that's a heavy old saw. If you are still (Stihl ;^ )) not sure, call a Stihl repair facility. There may be an old timer mechanic who knows.

Oct 19, 2015 | Stihl Ignition Module Coil 050, 051, 076,...

1 Answer

I have a honda gx 390 that kicks back when i pull the rope to start


The ignition timing may be too advanced . Some times if the pull start rope is not pulled hard enough it will kick back, The ignition fires just before top dead center , if not pulled hard enough it will kick back.

Oct 15, 2014 | Garden

1 Answer

Wont start-is getting fire&carb is rebuilt flywheel pinis ok


Check you fuel line configuration. More than one time they've come in with the fuel lines exactly backwards.

Jan 16, 2014 | Stihl Ignition Module Coil 050, 051, 076,...

1 Answer

I can't find a Stihl TS08 Cut off saw manual anywhere online so I can get the parts I need to use it.


Hello. STIHL Canada doesn't list either the 510 or the 760, it seems to be a STIHL USA item (??)Here is the link for the manual. It is about 1/3 of the way down the page listed under the heading " Construction Tools ", on the right hand side.

Let me know if this helped out.

http://www.stihlusa.com/information/info_product2.html

Jun 01, 2011 | Stihl Ts 510 760 Cut Off Saw Repair...

1 Answer

TS 510 av saw. My saw was running fine and just quite running after sputtering. Gas is good and mix is 50:1, Whats up with this? Bart


There could be a few problems. Check the air filters and make sure that no holes are present in them. Then check to make sure the unit has compression. A general check of the compression for a Stihl unit is to hold the unit up by the rope and it should hold itself up. If it slips down really quick or if it does not hold itself for more than a couple of seconds before the rope starts coming out, then the unit is low on compression and will need a new piston and cylinder.
Also another thing to check is the carburetor. With the new fuel with ethanol/methanol in it, it can damage parts in the carburetor. The sealant that went over the welch plugs will come off and it will flood the unit out because there is no regulation of the fuel going into the engine. You can try putting new sealant, such as clear fingernail polish over them, and see if it holds and will regulate the fuel correctly. If the air filters have holes in them then the low compression could be caused from dirt ingestion and it could have caused wear on the main bearings. You can check for bearing wear by seeing if the flywheel or the clutch will move up and down and sided to side. If this is the case then you will need to purchase a new unit.

Apr 05, 2011 | Stihl Ts 510 760 Cut Off Saw Repair...

1 Answer

STIHL TS760 cut off saw repair manual needed


Hello. Found the link for downloads, they also have contact info should your model not be online. http://www.stihlusa.com/information/info_product2.html

Hope this helped.

Mar 18, 2011 | Stihl Ts 510 760 Cut Off Saw Repair...

1 Answer

Replace pull cord


i roadworks63. Pull off the right side cover to expose the recoil, remove the rest of the rope. Now rewindthe pully c.c.wise until it stops then release it just enoughto align the rope holes,use a C clamp to hold the pully from unwinding. Insert the rope enough to tie a knotHeat the knot to make it hard,now slowly let the pully re..turn or unwind tieon the handle. You are home free.

May 17, 2010 | Stihl Concrete Cutoff Saw Rewind Recoil...

Not finding what you are looking for?
Saws Logo

Related Topics:

660 people viewed this question

Ask a Question

Usually answered in minutes!

Top Stihl Saws Experts

Joseph Mueller
Joseph Mueller

Level 2 Expert

346 Answers

rlev_7

Level 1 Expert

47 Answers

Norman Worley

Level 3 Expert

1273 Answers

Are you a Stihl Saw Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...