My Bosch WFL1800 starts cycling when turned on. Regardless of the settings is just cycles and wont progress. Is it worth fixing?

POSSIBLY IT HAS A BAD CONTROL BOARD .

Bosch washers feature a number of different settings that allow owners to determine how to wash clothing, at what temperature and for how long. While there is not a "Reset" button on the Bosch washer, owners of these appliances can still interrupt a load and change the washing settings in moments.

Step 1
Press the "Start/Pause" button.

Step 2
Turn the cycle selector to the "Off" position.

Step 3
Turn the cycle selector to a new cycle. A light will begin to flash.

Step 4
Press the "Start/Pause" button to begin the new cycle.

Source
https://www.hunker.com/13410561/how-to-reset-a-bosch-washer

by https://nichenudistdating.com/

The door is not locked properly.
Open and close the door again and press the "start reload" button (play and pause button). If necessary, open the washing machine door, remove some of the cothing items and then push the door closed again. You can also try switching the washing machine off and on again, setting the programme and then starting the programme.

take a look at your manual that came with your machine go to problems usually at the back and see what that says,or go to the bosch website and type in your model number its on the inside of the door.i would suspect a program fault.adrian,,,,,

circle at bottom right take it off there is a filter there remove it and look of obstructions.WATER WILL POURE OUT!

I have a 10 year old Bosch SMU 7000 and the drying function has ceased. Dishes are wet after all cycles. From what Ive read this isn't worth fixing because Bosch are so difficult to get into.

try these one of the following is not operating properly.

• Check the drain control lever
• Test the drain control coils
• Check the cam bar
• Test the timer control

If you wish to eliminate or reduce the volume of the end of cycle beep you can do so by powering off the unit and turning back on while holding the right button “Cancel/Reset”. The beep has 3 volumes levels and silent, press the right “Cancel/Reset” button to cycle through the settings. Power the unit back off to save you setting.

check to see if there is water in the bottom by the water valve and pump.

if it hums when you are in the wash phase then something is jamming the wash impeller like broken glass tooth pick found a necklace in one one time i think replacing the control board fixed the other problems on most washers the drain pump is separate from the wash motor haven't worked on bosch so not sure take off the lower spray arm and go down till you get to the impeller then do what you have to do clear it or replace wash motor