I have a kenmore range # 79094152310. And when I turn on the right front burner, the top of the oven gets so hot you would get burnt if you touched it, is this normal for this stove?

Is this an electric or gas range? We need to know the model number.

1. all these problems are given in the link below and the solutions with diagram is given in it
   
2. http://www.applianceaid.com/micro.html
   
3. A common flow chart for microwave repairs
   
4. A breakdown of a newer counter style microwave
   
5. Door switch caution and repair help
   
6. How can I get at the handle screws on my microwave to replace the handle? This has a common GE style microwave picture to help you.
   
7. How to install a common over the range microwave
   
8. Important Disclaimer
   
9. I set something on fire in my microwave and now it is dead...help!
   
10. My GE OTR ( Over The Range ) microwave is running but will not cook
    
11. My Frigidaire microwave is flashing a fault code in the display...what's up?
    
12. My GE microwave is flashing a fault code in the display...whats up?
    
13. My Panasonic microwave is flashing a fault code in the display...what's up?
    
14. My Sharp microwave is flashing a fault code in the display...what's up?
    
15. My Whirlpool microwave is flashing a fault code in the display...what's up?
    
16. My microwave light bulbs burnt out...caution!!
    
17. Ohm testing an capacitor
    
18. Some common Microwave FAQ
    
19. Some common components and how to check them with a ohm meter - like magnetron, high voltage transformer, high voltage capacitor, door switches and high voltage diode.
    
20. Stainless Steel Cleaning
    
21. Sparks from inside the oven area....why?
    
22. Tips on changing a common door switch
    

On this model (with the glass touch controls, right?), it is usually caused by a bad, sticking relay on the relay board, located on the back side of the oven, down near the bottom. Some of these models had a safety recall... You might want to check to see if yours is one of the affected models. (The model number you gave is not complete; find the complete model # & serial # on the range itself, usually on the range frame, visible when you open the drawer or open the door.

If you need further help, reach me via phone at https://www.6ya.com/expert/ronald_e6b9572cebe3ad27

If all burners and oven no longer heat, you don't have 240volts supplies to the oven any more. Could be wire burnt off terminal block where the cord attached or could be that your household electrical has a problem.

Since you are having problems with multiple elements the problem is probably the circuit board that controls them. This can be ordered and replaced. Be sure to unplug the stove before getting into the circuit board though.

Could you find the completer mode number because the number listed above your post is for a gas oven.
Look at following areas for the model number

• Under Right Front Burner
• Under Left Top Burner Front Or Rear
• Under Main Top Left, Rear Or Center Front
• Under Left Rear Or Right Front Element
• On Nameplate Inside Burner Box
• On Front On Burner Box Bottom
• On Nameplate On Oven Door Liner
• On Main Front Behind Oven Or Compartment Door
• On Front, Center Bottom Of Burner Box
• On Thermostat Cover Under Main Top
• Thank You, Sea Breeze

sounds like you got a broke or burnt wire on your stove just start at the cord and check all the wires

F1 Stuck touch pad Usually means that either the touch pad or the oven control (also called clock or ERC) is defective and needs to be replaced. If this fault code cannot be cancelled, replace the oven control (also called clock or ERC), touch pad, or both.