My ecosys fs-3900dn printer gives this error 0150:0119695

Question edited for a lot more clarity.
Question moved to Kyocera.

Nothing to do with a fax card, just make sure the back door is closed. It is normally called the 'Bypass Door' and gives card stock a flat run.

Kyocera FS-2026MFP "Toner Cartridge Improperly Installed"

Copytechnet https://www.copytechnet.com > kyocera-mita-copystar
May 26, 2020 - I have tried multiple things and the error message is still there. 1.) tried new toner cartridges. 2.) made sure toner waste basket was ...

Thread: 3552CI The toner container is not properly installed
Aug 1, 2020
Kyocera M6526CDN Error F375 & F246 & (Y) Toner ...
Sep 28, 2021
FS-6025 toner container not installed - Copytechnet
Nov 18, 2012
Kyocera ECOSYS M3655idn - Waste Toner Bottle Not Installed
Feb 21, 2022
More results from www.copytechnet.com

..

Call service message 6000 in Kyocera is a fuser error code. The fuser must have gone bad.

Regards,
Shrey

whai is the defect my kyocera ecosys fs-3900dn has error code call service 6000.0240336

The Call Service 2200 is a drum motor error. The motor or gears might need to be replaced. First remove and re-seat both the developer and the drum unit. The developer is directly under the toner cartridge - lift it up then out first, then open left side door remove the waste bin and press the button on the drum unit just above the waste bin pull the unit out (carefull not to touch the drum surface). Re-seat both units. If this does not work call in a Kyocera Tech.

The 7410 is a drum installation error code. This is typically caused when the waste bin is replaced. Open the left door and push on the drum unit just above the waste bin, usualy a click will be heard when pushing it in. Then power cycle the printer. This should fix the error message.

This is a Drum unit non-installing error: drum is not installed or not installed properly. The durm PWB EEPROM does not communicate nor mally. Defective connection drum PWB(YC1) and Connect-L PWB(YC3). Maybe defective drum PWB EEPROM or defective engine PWB or itis just the drum unit itself is defective.

Try downloading the manuals from Kyocera :
http://www.kyocerasupport.co.uk/index/download_center.false.driver.FS3900DN._.EN.html#


Please take a moment to rate this solution. Thanks.

Right click on the printer icon and choose properties. Your emulations are listed there.

0150 - Engine PWB EEPROM error. Detecting engine PWB EEPROM communication error.

Solutions:
1. Switch the printer OFF; unplug the power cable; wait 20 seconds; plug in the power cable; switch the power ON, If the error comes back follow the next solutions:
2. Update / Burn the latest firmware version. You may need to call a Kyocera Service Provider because you need a CF card (compact flash memory card) and the FIRMWARE.
3. Replace the Engine PWB (a board) - again you have to call a Kyocera Service Provider.