I checked all the breakers and the main switch all seem fine, engine runs but no power at the outlets, please help
High and Low Temperature Operation
Air temperature affects generator output. Output drops 1% for each
If the engine does not start:
1. Check the fuel tank for sufficient fuel. Refill with fresh gasoline if necessary.
2. Check the engine oil. Fill to the upper limit with fresh oil.
3. Ensure that the fuel petcock is open. The fuel petcock is open when the lever is perpendi-
cular to the ground (straight up and
.
If there is no power to the receptacles:
1. Turn the circuit breaker switches off and disconnect all electrical loads from the generator.
2. Turn the circuit breakers on and test the GFCI's by following the procedures in this manual
on page 1.
3. Place the voltage selector to the 120 Volt only positions (unless you are using a tool that
requires 240 Volts).
4. Turn the idle control switch off.
5. Turn the circuit breaker(s) off and reconnect the electrical loads. Be sure that the plugs are
securely connected to the receptacles.
6. Turn the circuit breaker(s) on.
7. If there is still no power at the receptacles, take the generator to an authorized D
service center. To locate a D
WALT service center nearest to you, call 1-800-4-D
E
1,584 views
Usually answered in minutes!
×