LL Bean thermo clock RAR312 temperature - Audio Players & Recorders

call the manufacturer for the manual,most listings are viruses,and im sick of getting viruses looking for things for people

Here's the user manual.

This clock keeps track of the temperatures for each of the last 12 hours. So on the bottom, you'll see the temp at 12 hours ago (-12), 6 hours ago (-6), etc. On the left side, you'll see the temperature in Farenheit go from +5.4 to -5.4 from where it is currently. So if the temperature is 70F degrees right now, and it was 65F degrees 12 hours ago, then it'll show -5 in the first -12 column. It will always be at 0 for the current hour on the right. The scale on the right is in Celcius so it does the exact same thing as Farenheit.

Hi, First check the both channel of clock and thermometer (you can see the controler in battery insertion of thermometer and you can set up channel by pressing ch button on the clock)
Next press F/C search button until the clock find thermometer and press F/C search button again.

take a paper clip and reset the reset button located in the battery compartment. Then, try each of the 3 channels until you get a reading in the outside temp field. Wait a good couple of minutes at each channel setting before determining the units are not pairing. Do this with the units side by side for signal acquisition, then once acquired, move the remote sensor outdoors. Hope this helps!

http://www2.oregonscientific.com/ulimages/manuals2/rar312.pdf

HOW TO SET TIME
1. Press [MODE] button for two seconds while in normal mode.
2. The digits and colon will blink which indicates the time setting mode has been enabled.
3. Momentarily press the mode button until the date or time digit you wish to set is blinking and use the up or down arrow buttons on the back to set the correct time and date.

low temperature/low humidity (LL)