I have a westinghouse tv vr-6025z and I want to hook up external speakers.

https://www.manualslib.com/manual/190228/Westinghouse-Vr-6025z.html?page=29&term=Headphone&selected=1

Does not have an audio out or a headphone out. According to the manual.

Check and replace damaged component/s at its main power regulator [SMPS] section circuit. Contact any service technician. If you wish to get some details; check the site linked here. Surf the site with patience. Pull up older posts.
http://electro-medical.blogspot.com/
http://electronicshelponline.blogspot.com/

hi i'd check the voltages on the connector on the power board, it sounds like you have 5v standby, i'd check for 12v and 24v or look for a tv tech in your area

regards
shaun

try the codes listed-remember not all remotes will work on all sets.....

Hello Jdreier520, I would be more than happy to assist you but would rather do it live. Please send me an email to [email protected] so I can better assist you. You can either provide me with a contact # or I can send you my contact information so you can call me at your earliest convenience. Please note I will need model #, serial #, and TW# all located on the back of the TV as well as what you have connected to the TV and how they are connected. Looking forward to helping you get your TV running in no time.

unplug TV and Bluray power cords from wall socket, replug HDMI cable in both units, replug power cords back in, turn them On and check.

Let me know how it worked. it seems Bluray player set its display resolution bit higher that TV doesn't support.
Please connect Bluray in TV by usual AV cable (yellow-red-white) and go to BD player setup menu and reduce HDMI Out resolution like 1080p to 1080i, then check it in TV HDMI input.

It could be if you are using HD that the show is not broadcasted in hd?

There is a method called a Power Scan this method allows you to search for all possible codes. Try this until you reach a code that carries all of the functions desired. If the TV mode button starts flashing rapidly during this process you have exhausted all possible codes.
Power Scan
1.) Hold down the clear "TV" button on the remote for four seconds, then press 500 pound ( #)
2.) Hold down the clear "TV" button on the remote for four seconds, press the big power button once.
3.) Press the channel up button once per second until the TV turns off then press pound (#).

Daniel Busa
DISH Network
Customer Service

Hello! I wanted to give you a few more codes that you may not have tried. I also wanted to give you the instructions to the power scan, which will scan the TV for the correct code. I hoep this helps!

Codes:
500
795
719

Power Scan:
1. Hold down the Clear TV button until all lights at the top of the remote light up
2. Press the red TV POWER button
3. Press and release the up arrow on the remote about once a second until the tv turns off.
4. When it turns off, press the # (Pound) button
5. Try powering the tv on/off, and try the volume. If one or more of these functions do not work, start over at step 1 again.


Becki Barned
DISH Network Customer Service