NEC DT300 Phone - extension phone not ringing but going directly to microphone. Unable to change Voice/Tone Setting without access code. Any idea what default code would be?

Free online manual:

https://www.manualslib.com/manual/600306/Nec-Dt300-Series.html


NEC DT300 Series User Manual

Free manual online:

https://www.manualslib.com/manual/600306/Nec-Dt300-Series.html



NEC DT300 Series User Manual

Hi you need to ask the installer to programme that specific extension to answer that ring sequence ,this can be done via your modem saving a call out cost.if you don't have a modem i strongly suggest that you get one and control the system remotely,

Nowadays it can be done via the Dtmf tones on that specific extension.

Hope this helps you.
John

Try accessing your voice mail from a different number. Just call your number and press pound once you hear ringing. If this doesn't work contact your phone company.

Voice mail was down. Called a service tech.

The call forwarding was canceled; try this
1. pick up handset or press speaker
2. dial the code for call fwd busy/ no answer (default code is 744)
or press the forward function key
3. dial 1
4. dial the extension (lead number of your voice mail)
5. press speaker or hang up

You have to change the rings from the voice mail server. If you don't know your way around the server, its best to get a local NEC tech although it is fairly simple to navigate. Depends on your skill. Typical default password for the server is NEC

Speaker - "60" - Speaker.

This is the default setting for Voice / Tone toggle.

Jennifer209, if you press FEATURE + the button VM is pre-programmed on what does it display? It should show the extension number pilot to VM. If you call it directly, what happens? If you get no answer calling it directly, your VM may be down.

Kaait, is it getting into the VM that's the problem, or doing things inside the mailbox that is the problem?