Have stripped down the Drill to clean the Bearings, But because of illness I did not get round to putting it all back together right away, Now I need a Manual where parts go Please.
SOURCE: Black & Decker Quattro, drill, won't tighten to grip drill bit.
give a good coating of oil then clamp chuck in a bench vice or alike and using short bursts with it set in the forward direction to free the chuck
SOURCE: Black and Decker corded drill won't tighten around a bit.
the chuck sounds like it is bad or maybe stuck from rust, what you can try and do is spray some WD-40 on the jaws and then try and holding the collar with a glove and run the drill SLOWLY in forward/reverse and see if it loosens up if not you will need a new one.
SOURCE: I need wiring diagram for a Black&Decker DR550
An electric meter can be used to find where wires go to switch
SOURCE: I have a echo HC-150 it won't stay on boggs down
Hi, either the carby is flooding and requires a carby kit or the spark arrestor or outlet in the muffler is blocked. Hope this helps, regards Phil.
504 views
Usually answered in minutes!
×