I have a generac wheelhouse generator it has a off on 240 volt switch that i dont see in the owners manual wonder if you might have any info on this

SOURCE: I need the owner's manual for Generac Power Washer

Here is the link for your machine.
http://www.generac-portables.com/document/index.cfm?doc=1439_0EN3W_LO.pdf

mamicheddy

• 79 Answers
• Posted on May 08, 2009

SOURCE: I have a Generac portable generator 5000 watts, won't start!

I am assuming the generator worked fine before the oil change. Now that you have done the oil change the genset does not start. These generators have a safety switch, which is basically an oil pressure switch that keeps the engine from running when there is not enough oil in the engine. Make sure that there is enough oil and if there is, look for a wire that runs along side of the engine to a round component. disconnect that wire and try starting. If it does not start then try to ground out the wire to the engine block. If this does not work, then there is other engine problems.

SOURCE: 10kw Generac Guardian not cranking, shows rpm sense loss

Sounds like Generator mode switch should be "ON".

SOURCE: I have a 17kw generac generator that will run

I have the 18KW model and was told that most alarms relate to a low battery. Make sure the battery charger in the Transfer Switch is properly feeding the battery or hook up a mobil battery charger to the battery and see if the alarm goes away. Good Luck.

SOURCE: When utility power goes out, the transfer switch doesn't transfer

Call an electrician.