SOURCE: Codes to program an RCA remote control
my remote will only work the volume. i need to program the remote to use menu to adjust the picture.
SOURCE: remote control programming
this rca should work on your rca tv , but here is the manualand how to clear a code for a device and reprogram it to the new device
scroll down to the second pdf file page ( thats where the instructions are for the reprogramming of selected device on remote ) http://www.remotes.com/remotes/documents/RCA/257003.pdf
SOURCE: I am trying to program my CISCO AT6400 remote to
Hello mw.... This remote does have a "search code" that works for the TV and the DVD mode.
So for the TV you first turn on the TV, then press and hold the TV mode key. While holding the TV mode key also press and hold the OK key. Release both keys and all the mode keys blink twice. Enter 922 by pressing the numeric keys on the remote. The TV mode key blinks twice to indicate a successful entry. Point the remote toward the TV and press play. I had to hold it to make it work. Once the TV turns off press Enter (at the bottom right).
Now I wanted to control the Power button for both the set-top-box (receiver/PVR) and the TV at once. To do this you have to press the STB mode key on the remote. Without releasing the STB mode key, press and hold the OK key. Release both keys and all mode keys blink twice. Enter the programming code 977. The STB mode key blinks twice. For the deconf device, press the applicable mode key (TV, DVD or AUX). The selected mode key blinks twice. You can select all three (TV, DVD or AUX) devices. Press Enter top complete the power switch control programming. The last selected mode key blinks three timesto indicate a successfull entry.
Hope this helps. Joe
thanks for choosing Fixya!!
108 views
Usually answered in minutes!
×