What does code flashing H-1 mean on Frigidaire refrigerator model fhs2611pf7

It is a warning that the fridge thinks the defrost heater is bad

Frigidaire side by side Model Ffhs2622msu Flashing H on the... H means that the refrigerator thinks the heater is bad. You'll need to pull everything out of the freezer and remove the back panel inside the freezer. You'll see the silver evaporator coils with the evaporator fan above it.
Apr. 14, 2020

What does flashing h mean on Frigidaire refrigerator?

Inside lower back wall of freezer.

HI-means high temperature, make sure no frost has built up on evaporator panel . put through a defrost cycle

FFHS2622MB3 FRIGIDAIRE REFRIGERATOR Manual ...

www.searspartsdirect.com > Kitchen Appliance Parts > Frigidaire Parts
Download Manual for Model FFHS2622MB3 FRIGIDAIRE REFRIGERATOR. ... ShopFor Parts. Click a model number to find parts at Sears PartsDirect.

For instructions on getting a new solenoid valve as well as various other parts, check the parts manual for the refrigerator:
Frigidaire refrigerator parts manual

Good Afternoon Richard, thank you for your post!

If an error code 4 is flashing on your Frigidaire refrigerator (GLHS35EHSB), it generally means that your refrigerator is experiencing an issue with the damper. The damper is either not opening or closing properly which typically causes the fridge compartment to not cool. One of the best ways to determine if this is a false error code is to reset the power to your refrigerator by either unplugging it or flipping off the breaker for about ten minutes. However, if you have already done this, at this time it is best to reach out to a professional to check the wiring between the damper and Main Control Board. Depending on the results, either the damper or Main Control Board may possibly need replacing. Best regards! - Z

E-1 is a Thermistor error. Thermistors are an electrical probe that senses temperature in different locations of your refrigerator and then sends that information to your control board. Model number? Sea Breeze
Frigidaire Error Codes.pdf then go to page 61

From what I remember a flashing 4 means "damper error". Send your model number found inside or on the outside of the fresh food section, The air damper is found between the freezer and fresh food section and regulates temperature in the fresh food section by opening wide for things that warm up your fresh food section example would be opening the door and letting warm air inside . The damper then closes to keep the right temperature. If you have questions please ask, Thanks Sea Breeze

Hi,

As far as i know this means the damper failed the start up test which is producing the error code 4. It could mean the replacement of a circuit board that controls the temperature as the H2O filter may have leaked and shorted it out.

You can disable the cooling system in your refrigerator by pressing the On/Off button located on the left side of the temperature
control panel. To ensure that you do not accidentally turn off the cooling system, the button does not work unless you press and
hold it for three seconds.
Once you disable the cooling system, all refrigeration to the freezer and fresh food compartments stops.
To turn the cooling system back on, you must again press and hold the On/Off button for three more seconds and see if that resolves the problem.

If not then you will need to contact Frigidaire themselves for advice on how to resolve this problem or to have and engineer come and take a look at it for you.

(United States)
1-800-944-9044

(Canada)
1-800-668-4606



Good luck.

I have Fridaire refrigerator model PLHS67EGSB5 and have electronic control flashing code 4 at the right side (Refrigerator side) . What that means and how can solve it.
Thanks, Anibal