I have a REPCO RP302TM it wont incline. I have been unable to locate a user manual to try troubleshoot this error. Do you have a manual online??

If you wish to get some details; check the site linked here. Pull up older posts...
http://electro-medical.blogspot.com/

www.retrevo.com/
Try this site to download the user manual for free.
http://electronicshelponline.blogspot.com/

Are you getting a reading on the display? Are you getting a incline error?

The E95 incline motor is out of calibration. Recalibrate the incline by holding the UP INCLINE button and the START button simultaneously for 5 seconds. This will put the machine into incline calibration mode. Press ENTER to start the calibration and let it run. It will take a minute or two.

Refer to page 25 (the last page) of the user manual, hidden right at the bottom.

This happened to mine, e7 is an error in the incline, meaning that the incline is too high or too low in the accepted range for the starting position of the treadmill. When the treadmill starts it looks to see if the incline screw shaft of the incline motor is in the correct position. If it isn't it gives the error message and shuts down. This happened to us after we had moved and the treadmill was bumped around a bit, this caused the incline worm shaft to move out of position, and that is why we got the error message.
To fix the problem I just took the cover off the motor area of the treadmill (WITH THE POWER OFF AND CORD DISCONNECTED) and located the incline motor, it has a threaded rod and a big nut coming along side the motor itself. It is the smaller motor. On the end of the threaded shaft is a plus sign cut into the shaft, so that you can insert a philips head screw driver into it and rotate the shaft. The shaft will rotate easily in one direction. Insert the screw driver into the end of the shaft and rotate the shaft so it goes as far into the big nut holding it as you can, don't twist it tightly, just make sure that the shaft has gone all the way in without binding, it still needs to rotate freely in and out. Put the cover back on and then switch it on. The treadmill should now start right up.

Technical Manual

Warranty

Spec Info

And here is some contact information. I was unable to locate a manual (owner's manual) online for you, but perhaps one of the following contacts can help you............

CONTACT: AirEase; attn Coushatta Fuller, 803-738-4114; 972-808-8450 (fax); [email protected]; www.alliedair.com.

TECHNICAL SUPPORT: Available 7 a.m.-7 p.m. Central, Monday-Friday, via Goodman's technical hotline, 888-593-9988.

Repco RP300TM wont start E1 error message

Check here for the user manual:
http://manualfox.com/link/reebok.htm

And maybe send them a manual request?

http://www.hillbillyhousewife.com/breadmachinemanual.htm

This was helpful to me when I didn't have a user manual.
Good luck!