In most cases this error is just a scam to make you install a new carriage, that you probably don't need. Without changing anything, attempt the following procedure:
Push the maintenance key.
Once you're in the greyed out menu, type #, *, OK
This will bring you to the service menu.
Select
Select "Engine Maint."
Enter code 3009002
Select Execute, press enter.
Switch it off.
Start the printer again with the cartridge door open.
Close it upon request.
At that point a 6 minutes ink reloading procedure should start by itself (if you're using original cartridges, this will cost you an eye as half of the cartridges will be drained).
After this the printer should be good as new, if no hardware issues are present.
One of the first things I read is the LASER is faulty... Tech required...
Have you seen this 2014 Fixya Post:
http://www.fixya.com/support/t25189201-ricoh_aficio_sg_3110dn_gives_sc_28213
Ricoh SG 3110DN Printer Clear 28212 Error
and this:
Ricoh SG 3110DN Printer Clear 28212 Error
Here is a PDF that may help you:
https://www.megauk.com/datasheets/Ricoh_SG3110DN-Error-28212.pdf have RICOH Aficio SG 3110DN that gives an SC 28213 error message as soon...
Anthony
SOURCE: HO TO FIND THE RIGHT DRIVER FOR RICOH AFICIO 250 COPIER
Goto ricoh-usa.com and select the correct drivers from the model number for your copier.
Use the PCL drivers only.
SOURCE: unable to start laptop
Hello,
I understand the urgency and also the importance of data stored in the laptop.
As the laptop is unable to start in normal mode let us try in safe mode.
Follow the steps below:
1. Turn the laptop off completely.
2. Press the power on button to turn it on and at the same time simultaneously keep tapping ' F8 ' key on key pad until you see a advanced boot options screen.
3. Select 'safe mode' and hit enter.
Thank you.
SOURCE: fuji finepix s1000fd displays zoom error on start up
Hello
The problem is that the lens has become stuck in the barrel. There are some DIY solutions you could try, but the
probability is that you will have to get it fixed by a professional.
Use
these at own risk as it may further damage the camera.
Firstly ,
try connecting your ac adapter or usb cable.
Try holding the
shutter button while switching on the camera.
Look at the lens ,
and if some of the lens 'circles' is misaligned or not concentric then
try wiggling it (while holding camera lens down).
Try gently
pushing or pulling the lens when it extends but this is risky as it may
cause the lens barrel to slip out of its guidance system.
Another
way to do this is to place the camera lens down on a hard surface and
then power it up. Be sure to use a soft cloth or something similar as to
not scratch your lens or casing. Let the lens push the camera up and
down a few times and sometimes the little resistance provided by the
camera is enough to get things going again.
Try hitting your
camera near the lens on the body with the soft tissue on the palm of
your hand.
Other than that , I would take the camera to a repair
center for a evaluation to see if it would cost more to repair than to
replace the camera.
If it is still under warranty I would suggest
you take it in before trying any of these steps and remove any
off-brand batteries or accessories as some stores are really fussy about
warranty repairs on camera's with non-brand accessories.
You can also have a look at THIS link.
Hope
the advise is useful. please do not hesitate to let me know if you need
any further assistance. Also, please be so kind to let me know if you
found this helpful.
Regards
Andrea
601 views
Usually answered in minutes!
×