Question about GE Washing Machines
Remove agitator and replace cogs
Posted on Jun 15, 2018
First, I'm not a General Electric Technician.
* Gear drive agitator not working or gears broken (you may hear the motor 'spin' on and off as it tries to agitate.
* Check your warranty (they can go from 3 to 5 years or even longer if you have extended service)
* Call your vendor (brand) for service.
*** the following is for information only ***
Posted on Jun 06, 2018
then your motor coupling has broken cost for part is about $20 can buy from your local appliance shop or order from REPAIRCLINIC.com
Posted on Jan 09, 2010
If the washer is stopped mid cycle it will default to rinse and spin. It will then get stuck in a loop. It is necessary to reset the electronics. Unplug the electrical cord from the unit. Wait 30 seconds. Turn the cycle selector all the way around clockwise. Turn it again and set it on any setting accept rinse or spin. Plug the unit in. It should begin a new cycle and be working normally.
Posted on Jan 29, 2010
SOURCE: How do I remove the
Anyone with loud scraping/clanging- we had that problem and saw that the large wheel the belt goes around is only an inch above the metal bottom.When we moved the washer with a 2wheeler it pushed the bottom up into the metal wheel. The racket it made was horrible. It left metal shavings ,too. You'll need to pull the bottom of the washer back out.Pull fromt panal off with putty knife.You'll need to lean or lay washer to one side.Put a pillow or cushion inside between the tub and housing side you'll be leaning towards. What I did was drill two little holes-one near the back center and one near the front center. I took a long piece of heavy string,put one end in one hole and the other end in the other hole-outside to inside.Tie the ends around each end of a 1x2,18inch board .Get the board to the back without damaging stuff inbetween-pulling on your back string for help. Make sure the board is against the bottom, get to where you can now pull your string 'handle' w/both hands,yanking and popping the bottom back out.Our washer now works beautifully and quietly.
Posted on Nov 08, 2011
Tips for a great answer:
Jan 12, 2018 | Washing Machines
Nov 21, 2011 | GE WDSR2080D Top Load Washer
Jul 19, 2011 | GE 3.2 Cu. Ft. 6-Cycle Super Capacity...
Sep 16, 2010 | GE WHSE5240D ENERGY STAR Super Plus 3.2...
Jan 09, 2010 | General Electric WHDSR209DWW Top Load...
Nov 13, 2009 | GE 3.2 Cu. Ft. 6-Cycle Super Capacity...
Oct 05, 2009 | GE WBSR3140DW Top Load Washer
May 30, 2009 | General Electric WHDSR209DWW Top Load...
Jan 12, 2020 | GE Washing Machines
Oct 23, 2019 | GE Washing Machines
159 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: