Tom Tom ONE Version 3

NOTE:
Anytime the batteryterminal has been disconnected, please initialize the driver's door power windowand front passenger's door power windowafter reconnecting the batteryterminal.

With ignition switchin the "ON" position, do the following:

1. Push down and hold the driver's door power windowswitch to completely open the window.
2. Pull and hold up the driver's door power windowswitch until the window closes.

Continue holding the switch for approximately one second until the switch changes from blinking to a constant illumination.
3. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions.

At this time the power window switchfor the passenger's door windowshould be blinking.
4. Push down and hold the passenger's door power windowswitch to completely open the window.
5. Pull and hold up the passenger's door power windowswitch until the window closes.
Continue holding the switch for approximately one second until the switch changes
from blinking to a constant illumination.
6. Check for proper operation of the "one-touch open and close" function by fully pushing the switch briefly to the "DOWN" and "UP" positions.

Try to start to the system in safe mode to check if this will resolve the problem.Safe mode is available to PS3 system software version 2.60 or later. To do the safe mode follow these steps:

1. Verify that the power indicator on the PS3 system is solid red, and then turn off the MAIN POWER switch.
2. Turn on the MAIN POWER switch, then touch and hold the power button.
3. Keep touching the power button even after you hear a short beep after 5 seconds.
4. After 10 seconds, you will hear another short beep and the system will shut down (release the button at this point).
5. Touch and hold the power button again.
6. Continue touching the power button even after you hear a short beep after 5 seconds.
7. Release the button when two short beeps are emitted after 7 seconds.
8. As instructed by the on-screen message, press the PS button to start up in safe mode

Try restoring your iPod. Firstly, make sure you have the same (or above) version of firmware on your computer somewhere. By doing the next step, you need to know that all data and settings will be erased from your device. If you are OK with this, put your iTouch into DFU mode by:
1. Plugging your device into your computer.
2. Holding down the power button for 3 seconds.
3. Without releasing the power button, hold down the home button for 10 seconds.
4. Release the power button, but keep holding the home button for 30 seconds.

Next, go to the iPod Touch panel in iTunes, and click on the "Restore" button. Now follow the on-screen prompts.

If you want to restore your firmware to a specific firmware (advanced users), shift-click the "Restore" button and select an ISPW firmware file to update it to.

Unlock vehicle. Enter vehicle. Close driver's door. Switch ignition ON and OFF. Remove ignition key. Press and hold unlock button. Press lock button briefly 3 times within 10 seconds keeping unlock button depressed. Release unlock button. Some models: LED flashes slowly for 10 seconds. Some models: Central locking system locks and unlocks rapidly to indicate correct programming. Repeat above procedure if central locking system does not work and LED does not flash or LED flashes continuously.

I think it destroy. The tom tom might of use to much power, and toasted the nuvi.

Do this whilst it is disconnect from a PC

Whilst it shows a map display touch the screen once.


Select the icon that looks like a spanner / wrench

Use the rght arrow on the display until you see a bunch of flags. (if you shoot past it just keep going until it comes ound again)

Touch that and select the correct the correct flag / language.

From Apple Website 1. Restart your computer (yes, you have too)
2. plug in your ipod touch (it should have the usb cord and itunes picture on the screen)
3. open itunes.
4. itunes will recognize the ipod. just ignore the message, and then hold down the home and hold button (on the top) for about 10 seconds, and after you count to 10, release the top hold button, but still holding home.
5. itunes will pick up the ipod, and once it does, release home.
6. Now click restore, and everything should work fine.
(if problem persists, try turning off firewall, and close all other programs)

your rechargeable battery inside has a limited life and has to be replaced when this problem happens.

While l was cleaning my tom tom 300 touch screen, some of the cleaning solution got in between the glass layers and I now have a spot that keeps moving. my question is there any way to open this up and dry this out or is the screen toast. Thanks mukat

Radioland,
I am having the same problem only I am trying to with mine only I am trying to update my guarenteed map. I have DSL and usually have no problem but it is taking over 3 hours to even attempt the download then I get a system error.