Simpson 9.5 top loader has code Co but cannot find it in the book.

If your Simpson 1043 10kg top loader is displaying an E90 error code intermittently before the spin cycle, it typically indicates a communication error between the control board and another component in the machine. Here are a few steps you can take to troubleshoot the issue:

1. Check for loose connections: Make sure all connections between the control board and other components, such as the motor and the door lock, are secure and not loose or corroded.
2. Inspect the wiring harness: Check the wiring harness that runs between the control board and other components for any signs of damage or wear. Replace the wiring harness if necessary.
3. Perform a reset: Try resetting the machine by turning it off at the power source for a few minutes, then turning it back on. This can sometimes clear up communication errors.
4. Check the control board: If the above steps do not resolve the issue, it's possible that there is a problem with the control board itself. A qualified technician can test the control board to determine if it needs to be repaired or replaced.

It's important to address any issues with your washing machine promptly to prevent further damage or more costly repairs down the line. If you are unsure about any of the steps involved in troubleshooting the E90 error code on your Simpson 1043 top loader, it's best to contact a qualified appliance repair technician for assistance.

https://www.google.com/search?q=ERROR+CODE+SF+ON+A+SIMPSON+WASHING+MACHINE&oq=ERROR+CODE+SF+ON+A+SIMPSON+WASHING+MACHINE+&aqs=chrome..69i57.14853j0j7&sourceid=chrome&ie=UTF-8

That most likely can be downloaded from the manufacturer's website.

Lift the top by unscrewing the screws in the back or remove the back panel and there you will find a code and test sheet. Very easy to follow if you follow it to a T.

http://manuals.appliancesonline.com.au/swt801/swt801.pdf

It has to be doing something?! If it is just shutting down it is because it is Not draining. So you need the drain pump replaced

If you need further help, reach me via phone at https://www.6ya.com/expert/steven_b77d19396bfe2249

I have a error code Ld come up on my Simpson eziset 5.5 kg top loader washing machine what does that mean ? Also is it possible to replace a sensor battery for that. Model and what size battery replacement do I need to ask for