My kenmore upright freezer electronic temperature control is reading F. What does this mean?

CE probably means a Communication Error between the high and low voltage boards of the freezer. First check if your freezer uses a 9V backup battery and replace that with a new one. Next check the wiring for corrosion or damage. Check where the wires connect to the boards and inside the door. (Note: the high voltage board controls the compressor.) You may want to check that the freezer is holding the correct temperature with a refrigerator/freezer thermometer.

Please add a comment with the model number of the freezer (including the three digit prefix) if you'd like me to check for a parts diagram and parts list.

I hope this helps.

Cindy Wells

Hi, go to this website and it will tell you what your error code means. Thanks!
Kenmore Freezer With Deluxe Electronic Control

Search Results

Freezer electronic temperature control manual... ' Sears ...

www.searspartsdirect.com > Ask an Expert
Jul 5, 2012 - I have a Kenmore elite freezer with electronic temperature control. ...my freezer was delivered yesterday, the control panel is stuck on of, ... an electronic control on front. the display is showing hi temp and door ajar. also an l in ...

Control Panel is not working right - Samsung

www.samsung.com/sa_en/support/skp/faq/239315

Samsung ElectronicsSep 3, 2015 - In case of wrong temperature display, possibly door opens so inside ... If the control panel is still not lit up after you plug the refrigerator back in, it may ... When initial installation, Temperature will show current temperature for a ... When the refrigerator/ freezer reach the set temperature, the blinking will stop.

Adjusting Side-bySide Refrigerator Temp Controls - Actual ...

? 3:50
https://www.youtube.com/watch?v=DFzTGKVo79g
Jun 27, 2010 - Uploaded by GE Appliances
CAN I TURN OFF THE DIGITAL CONTROL ON FREEZER AREA ONLY. ... I need to know How to reset this kind of refigirator, same front panel ... When you try to set the actual temperature, does your control show your new ...

Electronic Temperature Controls - ManualsLib

Turn power off for a minute and turn back on to reset!

Hello Michael - Sounds like the temperature control was accidently turned OFF. When this occurs the temperature control turns off the compressor, but does not disconnect the power to the light bulb or other electronics. Let's try activating the freezer by pressing the UP arrow until display shows "4" or desired setting. Allow 24 hours for temperature to stabilize. For future reference you can lock the control to keep from accidently changing the temperature setting. I ask that you please follow up with a comment on the post, at your convenience, to advise if further troubleshooting is needed or if the unit's status has changed successfully. Thank you.

http://www.managemylife.com/mmh/owner_manuals/370/KENMORE-Upright-Freezer-L0805601?brand_name_search=Kenmore+freezer+2532846.2801
try this web site that has a copy of a manual for this freezer. See if this has what you are looking for.

change the rubber washers on the compressor should work a treat...

if it is an electronic control freezer then the electronic control sounds as though it has failed if there is no digital read out

You probably have a defective thermostat or sensor for reading the temperature.