How can i replace the coil-valve of maytag bravos mod.MGDB850WQ0?

not good :>(

F01 means that the main relay control board inside your control panel has failed and your control board would need to be replaced to fix the issue.
Apr. 18, 2014

Maytag Bravos Dryer has F01 diagnostic code flashing and ...

Sears has a repair guide as well as online internet chat. I have no knowledge of this error, and only used Google to search for help.

https://www.searspartsdirect.com/washer-repair/error-codes/maytag-bravos-mvw-top-load-washer-error-codes.html

https://www.searspartsdirect.com/repair-guide/washer/how-to-replace-a-water-inlet-valve-on-a-top-load-washer.html

Sounds like the electronic shut off valves are not working or the main board is not communicating correctly with those valves

I have a Maytag Bravos washer and it had got progressively worse with LF code often having to restart several times. Checked every thing then bought a new inlet valve assembly from McComb supply. Replaced it and it works good. Note: wires were soldered on tabs.

Maytag Bravos MTW6600T Top Load Washer Run ... - Fixya

www.fixya.com > ... > Maytag Bravos MTW6600T Top Load Washer

Maytag Bravos MTW6600T Top Load Washer, run diagnostic test cycle related issues. Get free help, solutions & advice from top Maytag experts.

Maytag Bravos MTW6600T Top Load Washer Run ... - Fixya

www.fixya.com > ... > Maytag Bravos MTW6600T Top Load Washer

Maytag Bravos MTW6600T Top Load Washer, run diagnostic test ccu related issues. Get free help, solutions & advice from top Maytag experts.

Maytag Bravos MTW6600T Top Load Washer Diagnostic ...

Replace lid switch...switch is bad and thinking lid is still open about $12

Power it down wait several minutes than reapply power if this won't work the eeprom on the computer controller is bad

Here is a link to maytag dryer repairs http://apcoappliancerepair.wordpress.com/?s=maytag+dryer . The most common problem is the thermal fuse. My question is. Does the heating element start to light. If not...... and you have changed the ignitor and thermal fuse. Then check the flame sensor to see if there is continuity threw it. Power to the gas coils and ignitor runs threw the flame sensor. CLICK HERE to see a flame sensor on a GE dryer. They are the same on most units but Maytag will be on the opposite side of burner chamber.

Did you get a solution? Having the same problem.

(Washer is taking too long to fill)
Check the following:
Are the hot and cold faucets turned on?
Are the water inlet hoses kinked or clogged?
Are the water inlet valve screens clear?
Press POWER/CANCEL to clear display.

Hope this helps.........................