Https://servicenet.dewalt.com/Products/Detail?productNumber=DWFP12231
priority on Pos9 , 12 clean and lubricate it with sillicon grease , beware on several discontinued spare parts or even changed partnumbers.
SOURCE: BN125A Nailer will not fire even after rebuild kit
low air pressure may be the cause ,make sure you set the outlet to 70- 90psi
SOURCE: nailer drives one nail but driver pin doesn,t
Remove the air hose and open the nailer head section. Look for a foreign object in this are that could be jamming the drive pin. Also, make sure you are using the right size nails.
SOURCE: Firing Pin doesn't return
The piston is returned to its firing position by air from the trigger valve after the piston has fired. It relys on the piston sealing against the bumper at the bottom of its stroke, if the bumper was damaged when the driver shattered or it was put in upside down the piston will not return. Also the piston uses air fed into the return chamber from the little holes in the cylinder, if the seal over these holes is damaged the piston may not return. Basically change the bumper and the check seal on the cylinder.
SOURCE: paslode framing nailer when fired pin stays out wont retract
Check the anvil guide for damage first (ie: burrs, nicks, etc.) Then go to the chamber for the return spring. That is where your problems are.
SOURCE: I just bought a paslode imct cordless framing
check for a bent driver or possibly a jammed nail in the nose area.
2,225 views
Usually answered in minutes!
×