In toshiba 2309 copier machine shows me enter coin how it be removed

.toshiba 2309 LCD screen errors? that?
that is a huge
Toshiba's
e-STUDIO2309A/2809A
A printer, say printer,and is not a computer
coin,my wild guess is coin cell battery
full names work best;.

RTM ,read the manual yet,free
it covers all tests and all errors there
crystal clear.
no countr stated,by you
start here and get the book.

http://www.toshiba.co.jp/worldwide/region/index.html#euro

read chapter 7 yet
troubleshooting
that be first,this printer is very complex.
super complex really.
236 pages
page 202 lists all errors not one uses COIN word, is that a Typo? is coin = code? a double typo>?

either call a service tech.
or tell the full error on the lcd screen.
accurately and fully.
good luck.

Each signal will be enabled by configuring the se
tting code "08-9016" (Counter installed externally).
08-9016
0: No external counter (Default)
1: Coin controller
2: Card controller (For Japan only)
3: Key copy counter
5: Coin controller supporting mixed-size

Step 1: Remove all the paper that is jammed in the machine. Follow the steps on the touch screen to locate the jammed paper.
Step 2: Turn off the copier with the power rocker switch on the right side.
Step 3: Hold down the 8 and 0 on the numeric keypad while turning the machine back on.
Step 4: Enter 400 on the numeric keypad and then press the Start (copy) button. As you type the 400 will show up in place of the D
Step 5: Enter 0 on the numeric keypad and then press the "Enter" button on the touch screen.
Step 6: Power down the machine with the same power rocker switch as in Step 2.
Step 7: Turn on the machine with the power rocker switch.

my dear reast all maintaince counter in program 08

You have a corrupted hdd promblem on you toshiba. You should find another hdd and the firmware and make them using usb stick

Step 1:- Switch off the machine
Step 2:- Press 0 & 5 simultaneously
Step 3:- Switch on machine.
Step 4:- The display shows test mode.
Step 5:- enter code 200
Step 6:- the machine starts automatic adjustement of auto toner sensor , and when the display shows adjust mode then press enter on the display.
Step 7:- Now switch off & on and check the problem should be
resolved. If problem continues then maybe, changing your
developer may solve the issue.

Hi,
How are you this is jack my id [email protected]
your copier toshiba 161 show H...4

Dear, Follow the procedure.... press C(CLEAR) BUTON+ PHOTO BUTON+C BUTON+PHOTO BUTON..... Your copier enter special mode
Then you press 14 and start key.... copier ...ok
PLEASE VOTE ME
Thanks,
Best Regards,

Hi how are you this is jack.... [email protected]

Dear you on your copier 0and 8 mode and enter 690 press stars key then press ENTER. WHEN Copier show REBOTE THE MACHINE . THEN turn off the copier and simple on.
PLEASE VOTE ME.
Thanks
Best Regards,

Hold "0" and "8" while turning on machine.....continue holding until machine enters service mode. Enter "400" press enter. Enter "0" press enter. Power off / on. If code returns, machine needs parts replaced. Do Not keep resetting, may cause damage to Fuser Unit.

Enter SP mode and select SP5113 - Optional counter type.

Good luck and please rate me, thanks.