All it did was turn on a green light left of the power button the monitor was black and the zoom did not extend
Very often with a camera that old with battery types that it uses there is a problem the contacts that must touch the battery when it is inserted.
I use WD40 Contact Cleaner and have had good results, simply rubbing both the contacts in the camera and also the contacts on the battery.
I am certain you have checked that the batteries are indeed fully charged.
I am also guessing you have made certain the battery is installed correctly...many Sony cameras can have a battery installed "Upside-down".
And I am curious if you have tried the USB charger.
SOURCE: Monitor goes blank less than a second after turning on.
do you have an aftermarket video card. In the bios you have to tell the computer if it is looking for a agp/onboard or PCI video card. Either that or the video driver or settings are wrong Try safe mode to check
SOURCE: Sony Cyber -Shot
try gently pulling and twisting the end of the lense and i mean gentle dont pull till it pops than switch it off and on again and you problem should be solved
SOURCE: monitor comes on, I can see everything perfect then goes black
"Most" newer monitors will let you know if the are no longer receiving a signal. Sounds like the backlight is burnt out. Try getting a bright (LED works best) flashlight and shining it at the screen at all angles to see if you can see any of what you were doing. If the backlight is on the fritz, either return it on warranty or buy a new one.
SOURCE: sony cyber-shot 7.2/display screen is black and
CCD Failure!
known problem contact sony for free repairs dont worry just call them they will do it even if u are out of warranty
see this for sample advisory and problem detail
http://esupport.sony.com/US/perl/news-item.pl?news_id=161&mdl=DSCT1
SOURCE: SONY CYBER SHOT NOT WORKING
Hello samtx930, "turn off the power and on again" its a very commen problem and occurs when the lens block assembly start malfunctioning. Actually the slide motor not work properly and until the lens not come out completely the camera will not work, that's why the error message appears "Access" and then screen shows "turn off the power and on again". In this situation you have to replace lens block assembly.And the part No. is with description is given below: 1-788-363-11 OPTICS UNIT (ED13A) Thanks for using fixya.
55 views
Usually answered in minutes!
×