Trying to set up my westinghouse flat panel monitor keeps saying no signal input what do i do

test box in all hdmi inputs. see if it's only one port
make sure the box is working test on other tv if possible

Should be a setting in the TV to select the input source.

If no signal via the cable fitting try hooking set via one of the sets of jacks on the back (audio/video or component) to see if coax input or tuner is bad.

If the set works with a DVD etc hooked to one of those inputs and your cable is good--maybe a bad tuner in the set---also if using a box try hooking cable direct to set to rule out the box.

I'm not sure what you are plugging this into, or through what type of connection; but if it is plugged into VGA make sure none of the pins are bent on either side of the cord, also make sure it is set to pick up the signal from the right input. If you need anymore assistance with this please let me know.

If the monitor has two video inputs - a DVI-D and a DSub VGA then the monitor needs to be switched to the DVI-D video input.

its sad it looks auto run virus , install avira antivirus freeware or avg 8.5 free antivirus and throw that virus out,

domnickr

There are several fixes for this problem.

1) You can unplug the TV for a few minutes and try again.

2) You can turn off the TV then hold the Power button down for at least 10 seconds (resets the processor)

3) Go to the settings menu, select factory reset.


Good luck

timberline did you reset the tv to factory setting this may solve the problem

Use a different monitor to test and set up the PC, try lowering down resolution settings, and test also the video cable.

Try also changing the monitor input channel, just in case this is set on a different connection input.

Have you tried to click the source button on the tv? It is the second button from the bottom on the right hand side of the screen.

I doubt your tv/monitor is turning off, it just isn't getting any input. D-Sub is the "pc monitor part".

Try clicking that button, give it sec, the hit it again. It will go through all of it inputs. If TV is what you are trying to find, it is directly after the Video input (green letters, top right hand side of the screen.) Keep hitting the button until TV shows up.

Good Luck!