I have super general washing machine 7kg top load showing error code e3

SOURCE: error codes for indesit front load washing machines

The F002 error codes relates to a motor problem. Do you know if the motor spins ?

SOURCE: washing machine displaying E90 error

an E90 fault is a problem relating to the main control module found behind the front facia. it could just be a bad connection on the board connections though

Barry Coates

• 3463 Answers
• Posted on Jan 13, 2009

SOURCE: Ariston Front Loading Washing Machine error code F07

Error code F07 is indicating that the heater relay is stuck for one reason or another.
This could be a board problem, as this where the relay is located.
However, it would be worth checking that the heater is o/k before you do anything else., as this possibly could cause the relay to malfunction.
Plz rate my solution.
Thanks.

SOURCE: We are getting error code E3. What does this mean

Looks like you have either a stuck drum (does not spin) or an electrical fault that make the washer think the drum is not moving.

From a 2006 Technical Bulletin:

E3: Machine control is attempting to drive the motor but is not seeing any tach response. Visual Check shows motor is not moving. (Locked or Hall Sensor fault.)

Specifically, it could be:

1. Spin drum stuck – Verify that the spinner moves freely to eliminate this cause.
2. Hall Sensor (integral part of motor) fails or is loose – When the Hall Sensor fails or becomes dislodged, the control doesn't recognize that the motor is spinning and shuts down. The result will likely be an “E3” code in the worst case, or “SUdS” if it is only getting a partial rpm reading. Check wire harness connector(s) to motor.

Unless you are really overloading your machine you likely have an electrical fault, or a failure in the drive train--especially if the problem is intermittent. Probably time to call in a technician.

SOURCE: error code 8

Could be water valve stuck open/ malfunction on coil. or possibly level control valve.