Where to hook speakers up on a Kenwood NK-45 - Kenwood Car Audio & Video

The four top sockets marked "A" are the main speakers. If you are only using two speakers connect them to these sockets. The red ones are positive the right speaker being connected to the ones on the left (with the back of the amp facing you).

Press the A switch on the front panel to listen to them. If you want to connect an additional set, connect them to the B connections.

Look on ebay, for starters...worked for me...NK

You can run the speaker wires to the speaker level input on the amp or i believe you can run another set of speaker wires spliced into the existing wires in parallel to the speaker level input along with the speakers that are already hooked up if you are using the amp for a sub or other speakers that you have added to the existing system.

Battery is yellow
Accessory is white/red
Ground is black
Illumination is red/black
Power antenna is yellow/white
LF speaker +blue/green - grey/black
RF speaker +red/green - brown/black
LR speaker +blue/yellow -grey/white
RR speaker+red/yellow -brown/white

use the soldering iron ,and to re-soldering the parts of the NK board or the crt socket,and the RGB Connector NK borad thru the [email protected](rongxin)

kicker or rockford for subs. hifonics, power acoustics, kenwood for amps. pioneer or alpine for cd deck.