I have a GE top load washer model G157. When I

Question edited for clarity.
Question moved from Cars and Trucks Category.

Call for service. You have and undocumented issue.

https://www.google.com/search?q=hotpoint+g157+washer+clicking+noise
and
https://www.google.com/search?q=hotpoint+g157+washer+won%27t+shift+between+normal+and+gentle

..

A lid switch doesn't regulate water capacity and if the lid switch fails, the machine will not execute a complete wash cycle. If the washer functions but only at partial water fill for the selected load level... then the problem is likely a clogged pressure switch tube or a malfunctioned pressure switch. Got mine used online - fixed the very same issue.

You have the wrong category, post question to Washing Machines Category. A bit more info would help, like what the problem is.

Hi,
If you are having a problem with your top load washer then check out this tip...

Washing Machine does not Pump or Spin
http://www.fixya.com/support/r4617986-washing_machine_not_pump_or_spin

If you are having problems with your front load washing machine then checkout this tip...

Front Load Washing Machine not draining and or not spinning
http://www.fixya.com/support/r4784376-front_load_washing_machine_not_draining

heatman101

Try different water temps. Maybe your cold water valve is bad. You cannot get it to spin? On any cycle?

If you need further help, reach me via phone at https://www.6ya.com/expert/dan_73bbd84fe1d95b61

The motor reverses rotation to spin. Your motor is going bad.

Cold water pipe had become frozen. FYI this model of washer has a nice feature whereas you can test each component i.e. valves, by setting the timer and reading the LED's on the front panel. Instructions are in the schematic.

Hello rschneeweis
Welcome,

Sounds like a seal or drain hose is leaking or the clamp on a hose has vibrated loose.

Water leaking out the bottom of the machine when washing machine begins agitation cycle. If the machine is turned off the water stops leaking even with the tub full of water.

Let me know if you found it and how you do.

Huuum
Please remember to leave a rating

Some models have a bolt towards the bottom of the outside of the agitator, depending on model. If it has one, take out out and you'll have to yank on it VERY hard to get of off (you'll most likely lift the machine off of the ground a few times in the process!)

If the bolt isn't there, its under the top cap of the agitator "somewhere". You'll still have to yank up on the silly thing to get it off after taking the bolt out.

Good luck!

  These older units had an insert in the agitator that would strip out.  Remove your agitator and take to a parts store. They should be able to help you out.