My frontload washing machine won't start a cycle ,it won't spin and it sounds like water starts to fill and then stops about 3 seconds after it starts.. model # LTF2940ES0
Firemanjim was dead on. there is a white connector on the mother board on the bottom of the cabnet. there is two sets of wires, one small and one large. the small wires connect via a small white connector. you can gain access by lifting the lid and pushing it back down. thanks fireman jim!
LOOKS LIKE WE ALL HAVE THE SAME MODEL AND SAME PROBLEM. WHAT'S THAT TELL YOU? THESE DAMN MACHINES SHOULD BE RECALLED. MY REPAIR PERSON CAME OUT AND REPLACED THE SECONDARY DOOR LOCK SWITCH. TURNED ON THE MACHINE AND OTHER CODES STARTED TO FLASH. TURNS OUT BOTH FRONT AND REAR MOTHER BOARDS BLEW. ITS NOT WORTH SPENDING THE MONEY ON THEM SINCE THEY ARE OVER $200. EACH. FRIGIDAIRE WILL HEAR ABOUT THIS!!!!!!!!!
OK Check elec plug at motor . Mine was doing exac same thing . Take belt access panel off back and pull wire plug off motor and push back firmly on . This plug does not have a tab so vibrates off . Good luck .
Check to see if any wire is loose on the door switch, after removing the plug from the wall socket........Also check your water inlet hoses and hose filter screens. The water inlet valve on wall shd be opened well, before you begin wash.
689 views
Usually answered in minutes!
how do i check if the door switch is bad
Frigidaire, front loader washing machine (3 years old) starts to fill with water for about three seconds and then stops ... checked the soap dispenser, inlet and outlet hoses, and water pump. All seem to be OK. Any ideas on how to resolve this problem?
How do I check the door switch for loose wires? I also have a front load Frigidare washer model # LTF2940ES0 (2 years old) which does not drain, spin, fill...
The washer attemps to fill for about 3 seconds and then stops.
start washer startes filling stops and wont run
×