Maytag neptune washer hot water fill problem

Repair needed on Maytag Neptune washer - Home Improvement ...

www.dslreports.com > ... > Home Improvement

DSLReports
Aug 5, 2007 - 19 posts - ‎8 authors
Forum discussion: We have a Maytag Neptune front-loader washing machine that ...the drain/spin cycle after a wash even though the timer continues to ... related circuit board failure" their Neptune washer will lock the door, turn on the ... then will either not start tumbling or will stop operation mid-spin cycle.

How To Fix A Washing Machine That Is Not Spinning or ...

removeandreplace.com/.../washing-machine-or-washer-dryer-is-not-spin...

May 13, 2013 - The absolute first thing to do to your washing machine that will notspin or drain (whether it. ... I was so fed up with the machine sometimes refusing to spin or drain the .... I just did a load and it stopped midcycle with e and f error codes.... I tried different cycles but all that happens is the door lock engages ...

Maytag Washer Troubleshooting - YouTube

cheak the belt sounds like its snaped

replace timer. 30 to 50% of value of new machine

Bonnie,

NF = No Fill the control board receives signaling for the washer during the water fill cycle. With most cycles the depth of water is around 3.5 inches in the wash basket. I know a Bulky Wash cycle selection will fill the wash tub to a high fill which is about 7.5 inches of water in the wash basket.

Is the washer filling the machine with any water? Do you hear water entering the machine? If you are doing a cold water fill and there is no or very little water in the wash basket with the NF error code. Try a Warm or Hot fill and see if the machine will fill and start the wash cycle.

Assuming you are doing cold water wash loads. You could have a water line block at the inlet screen or a failed cold water inlet valve which will not open. Try the above and let me know the results..........Rich

For troubleshooting assistance please click on the following link

http://maytag.custhelp.com/app/answers/detail/a_id/2027/kw/continues%20to%20fill/p/293/r_id/108284

since you can drain it
take off the back and watch what happens when u turn it on
i believe you make have a loose drain connection

Does it fill when the machine is powered down?

If it does then the fill valve is stuck open and needs replacing

If it does not then you need to check the pressure switch and the air bell on the outer drum which probably has a ball of jellyfied soap in it.

If you take the back off you will see a thin plastic or rubber hose going from the bottom of the drum to a small flying saucer type object.

If you pull the hose off the bottom connection and blow into it you should hear a clicking noise from the pressure switch.

If it clicks then clean out the air bell and refit the hose .

If it does not click then get a new pressure switch

A repairman would test it live but that is not recommended for untrained people

if the water continues to fill even with power off, and you have to manually shut in off at the wall valve, the 3-way inlet valve is stuck open. you have to replace it. $90

does the water run when you unplug the machine? if so then you have a bad fill valve,

need more information is it top load or front