Don't know how to change video input without

Normally you HAVE to use the remote. If it is on the television, there is normally a 4 arrow button and there is a button in the centre which is enter.

Remotes are easily sourced and a authentic copies of the original. Google

make model replacement remote

Without remote control, you can't select its inputs. No other way.

If your TV has a 'Menu' button at its front panel, you can surf through its menus and can set the input select option to make it into tV/Video option. If there is no such button, no other way to select the input selection without its remote control.

If you get a cable box that has audio/video outputs on the rear connect them to a identical input on the rear of the set----direct connection and bypasses the coax fitting most sets have.

Go to the input you hooked to and leave set there--change channels via the box with its remote or manual buttons.

Hi the only slight chancer you have of doing this without the remote and this will only work with some tellys is to have the telly switched on then the device you have connected to the video input have this switched off at the wall then with the telly on switch the device on your trying to get the telly to pick up now some tellys will pick up the signal and go to that input channel, if how ever this dont work your going to need to go out and buy an all in 1 remote, these remotes cost next to nothing to buy you can get them off the well known auction site or from your nearest cheap shop such as discount stores that sell goods for next to nothing these remotes will work on all tellys and would solve your problem if the way i told you dont work.

Im sorry their is no easy way to get it to change but without the remote your pretty much stuck unless on the telly you have a button that looks like a square with an arrow running from left to right if you have this button then pressing this wil change the input source for you, if you dont have this then the only option would be an all 4 1 remote.

let me know how you get on or if you need further assistance ok

If you don`t have input selector on the set or in the menu you might be able to get it with the channel buttons, that would be right below channel 2 or above 125

ye a tech can do that.he'll make a extension of the video input at rear.or you can buy a switchbox for that.

There might be an input button or menu button on the front of the TV (or behind a door or panel) that will let you set it for video input.

If you have lost the remote, go to any electronics store and buy a universal one. I have programmed many generic remote controls, and they all work fine for adjusting the video inputs. Not all television sets allow their video inputs to be switched without the remote. Most likely you will have to buy a replacement.

How to get the input on the tv without the remote