Frigidare FRS23KF6CB manufactured 03/07 ice maker water fill wont shut off

You simply need to replace the=> 242252702 Water Inlet Valve It is allowing water to continue to flow after it turned itself off., Thanks, John Tripp Appliance 911

There should be a float or electronic water level sensor that will tell the water to shut off, if it has calcium from the water on it or the float is damaged it will keep sending water until manually shut off(pull the plug). I would look for a water level sensor of some sort and clean or replace it. If that doesn't work it could be a sticking water fill solonoid which you should then replace

if it has ice/water in the unit,check the hoses going from the supply line at the inlet valve on the refrigerator rear section,if theres a hole in the tube,when the ice maker calls for water to fill the ice trays it will leak out this pin hole during the time the water supply valve is open and then shut off when the valve closes due to no pressure on the line then,thats probably the reason the puddles not always there

Icemaker generally has only about a 6 second fill time. Most likely a particle made it past the screen in the fill valve and would not allow the internal diaphram in the valve to seal. You can't get to the internal parts of the valve. Replace the valve. Consider an in-line filter installation before the refrig hook up to prevent this from repeating.

the leaking water is the problem. it needs to be fixed, but till then defrost again, use a fan it speeds the process, SHUT OF WTER to ice maker. restart fridge it will work normally. now find parts needed to fix the ice maker water feed.
the leaking water overwhelms the defroster. and causes a coil freeze up, this impedes cooling and air circulation over the evaporator coils

are you sure the water comming from the icemaker or the defrost drain line clogged

May be an issue with the cam that operates the ice maker. U can pick up a new ice maker for about 40 bucks on ebay.

Lots of things could be bogus. If the solenoid does not open, no water in tray - no ice. If tray does not get warm for fingers, fingers cannot push ice out - no ice. If freezer is not at least 10 degrees, no ice making at all. If cam motor for maker is bogus, anything could be out of whack.

Make sure that the ice maker is in "on" mode.

icemaker wont dump ice

u r missing ice

press the reset button (black) on the bottom of the icemaker, the system will go through a cycle, and water will pour into the tray.