Leaking westinghouse 9.5kg washing machine

indicates that the tub support air dampeners are failed allowing the tub not to be level
normally there is a small amount of water in the tub as the spin starts to allow the cloths to move around for balance but when the air dampeners break there is no initial control for the balance so the tub gets all out of wack

If its leaking during the fill cycle, its one of the water valves (solenoids) or associated hoses, loose clamps, etc. If its leaking during draining its the drain hoses, pump, clamps etc. Easiest way to tell. Pull it out, if you can remove the back, run it and look for the leak. Just don't touch anything while its running, you don't want to lose a finger or get electrocuted.

You will need to replace the bellow. Here is a link to the part you need.

The back and sides are one piece. The front comes off (two clips under top, one on each side about 2 or 3" in from outside - two screws on bottom directly below clips). The top will lift up on the rear hinges, the front lifts about 0.5" and comes off.

Hello, Thank You for using FixYa. I will be helping you today.The only thing that has oil is the sealed system. So if there is oil leaking you would have a leak and the unit will stop cooling.Are you sure something didnt just spill and is leaking out?
Thank You and please rate my answer if it was helpful..

Question is not clear
Any how try to fix it with some sort of Plastic / Steel Putty like Araldate / Belezona / Devcon / Weicon / Mseal etc ...

could be leak ing from your pump

check the door rubber for any tears,this is also called a boot glove.

removethe lower acess panel 3 screws across the bottom , run the cycle and watch to see where exctly the leak is coming from it should be quite apparent

you will have to be nice to it as it will come out and with some fairy up liquid you can put it back so easy