Code nf shows on my washer

www.fixya.com > ... > Neptune > Maytag Neptune MAH5500B Front Load Washer

Apr 14, 2009 - CODE IN MAYTAG WASHING MACHINE Hello & Welcome to FixYa NF error in yourMaytag is displayed due to no fill condition, when the washer tries to fill but ... SOLVED: Maytag Neptune MAH6500AWW '03 front ...
10 answers
Nov 9, 2016
SOLVED: HOW TO FIX NF CODE IN MAYTAG ...
2 answers
Oct 2, 2011
SOLVED: Machine is flashing nF code
10 answers
Jul 13, 2011
Maytag Neptune MAH9700 Front Load Washer Nf code ...
10 answers
Jun 21, 2011
More results from www.fixya.com

NF and 4E = No Water Feed = Washer Not Filling. This means that there is an issue that is preventing your washer from receiving water into the water inlet valve. The troubleshooting steps below apply to all types of Samsung washing machines including front load, top load, and washer and dryer combos

https://removeandreplace.com/2015/12/16/samsung-washing-machine-shows-nf-or-4e-error-code-what-does-this-fault-code-mean

Samsung Washer Error Code NF (Fixed ...

www.appliancerepairlesson.com/.../samsung-washer-error-code-nf-fixed/

Jan 11, 2014 - What does the error code NF mean on a Samsung washer? ... You can set the washer to any cycle and test each solenoid for proper voltage. ... Next would be to check the screens on the back where the water hoses connect. ..... Hi, you don'thave any power to the water valve wires when it should be filling?

Something like a seal or hose is leaking , water has got into the base and activated the anti flood switch. Good luck

NF--No Fill
water inlet valve no good
not opening to let water in

The nF error code stands for "No Fill."

If you have just installed your washer and it will not fill, or the display shows nF, check the following:

• Make sure the door to the unit is tightly closed.

• Make sure that both the hot and cold water lines are connected (cold to the cold and hot to the hot)
• Note: If you do not have a hot water source, you can hook up the cold water source to the cold input on the back of the washer and another cold water source to the hot input on the back of the washer (but NEVER a hot water source to the cold water input on the back of the washer).

please see the cause and proceed to test the water inlet valve can be defective and replace it.use the common sense,see the diagram
God bless you
Water Supply Error occurs when water level frequency does not show changes more than 100Hz or water is not supplied up to the preset water level after 10 Minutes or more at the time of initial water supply. The error status can be cleared by turning the POWER switch OFF and back ON.

NF(No Fill) code indicates that the washer is not getting enough water supply. Check if wwater supply is turned On and water is coming through the pipe. Then the fill valave can be clogged. t can become clogged with sediment over time
Stop the water supply and then remove the hose and then check for any clogs and if they are fine then in your case most probably your fill valve must have gone bad for this problem.Replacing it must solve the issue.

try changing the washers in the hoses / don't use red outside hose washers/ but hi pressure for fill hoses . home depot should have them . and ck the valve screens at the washer side . clean screens good washers . ( water flow's and washer should work .. mm

FL is a flood condition fault, too much water in unit. i would turn off water supply and try to spin water out. select spin button, should put 8 min on timer try startin that water should pump out then if not you got somethin stuck in pump (lint likely)