Samsung wf306law/xaa Had a ND code. drained lines, pump etc. But won't Spin, nor do i get a error code.

SOURCE: Samsung Washer WF306LAW stopped draining and won;t spin

Drained the water from the tub into a bucket. Since the water flowed through the disharge tub I knew there were no obstructions in the line. I then took took the discharge pump out and took it apart. Turned out to be a bobby pin in the motor that was jamming the impeller.

Put it all back together and it works just fine. Took me about 2 1/2 hours total to diagnose and repair.

SOURCE: i have a samsung front

Hi from retired Englishman in SW France,
My Samsung list says 'nd' stands for 'no drain'.
I would gently suggest as a first step that you clean the drain motor/pump lint tray/filter. So many 'faults' are caused by blocked filters and many machines will not even go to rinse or spin or release the door lock if there is any water still left inside.
Following are my complete and generic guidance notes for checking both the drain motor filter and the drain motor ;-0)
REMOVE POWER AND ENSURE YOU HAVE A WATER RECEPTACLE/RAGS TO SOAK UP THE WATER WHICH IS BOUND TO POUR OUT (alternatively use a wet vac as sensibly suggested by VinnyB1234!)
If you are unsure where the filter is, it is often behind the front lower (kick) panel (or in some machines at the rear in an awkward position!). These panels are either held on by (plasic) screws or will just pull off. Most filters are held in by a round cover/knob. Sometimes the filter will not come out with the cover and you will have to persuade it to come out to play.

It's surprising what people have found in theirs! It is always worthwhile checking it on a regular basis.
Now- whilst the filter is removed it is normally possible to see the drain motor and ensure it is not jammed by a foreign object such as a needle or a toothpick. It should be able to be turned by hand/finger- the power IS OFF!
At this point it is also possible to test if the motor works. No clothes or water in the machine, select a spin cycle and put the power back on. You should be able to see the motor turning at some point, possibly straight away. Using something suitable like a glove see if it is easy to briefly slow the motor down. If it is easy then the motor is malfunctioning.

If this has assisted you please consider a 4 thumbs up for the rating.
Thanks and good luck!
John C

SOURCE: MY WF218ANB/XAA WON'T DRAIN BETWEEN WASH AND

Hi gumby323,

Drain pump may be clogged. Please follow my below tip on the fix:

ACCESS, DRAIN & CLEAN THE DRAIN PUMP FILTER...

If this does not help, the drain pump may be faulty.

Kind Regards

JEDEMEYER1

* If this solution helped you, please rate it