How to fix Linksys Router Setup Error Code 302 ?

SOURCE: 2wire 2700hg-b wired router wont allow setup of Linksys WAP54G access point

the ip address of the 2wire router might be different from the ip address being used by the wap54g (ip address is 192.168.1.245 by default) that's why it's not being detected.
you need to directly connect the wap54g to a computer and set the computer to use a static ip address (ex. 192.168.1.240) and run the cd that came with the wap54g. you need to set the ip address of the wap54g to the same segment being used by your router to make them see each other

hope this'll help you and just ask me if you have other concern

ciao!

SOURCE: Linksys Wireless G Router Set up

I ended up loading the router setup cd onto another laptop, and it worked fine. I still don't know why the first laptop had the error code, but they now both, work perfectly fine. Thanks, anyway.

SOURCE: setup problem

please call dlink tech support at 877-453-5465. just an advise on how to handle the call when you reach dlink tech support (agent); do not agree to call back after you troubleshoot with them (they'll be giving you a case id reference# and be advising you to check your pc or call "who" and call them back to continue the troubleshooting). insist to the agent that he need to resolve the problem asap (by the way, agents are not allowed to drop the call or they'll be dead-history!). and if the agent still insisted you to call back, ask for a "senior level technician" to finish the job (escalate the problem).
fyi: dlink tech support handling time to resolve a call is 15 to 18 minutes only. if you reach that 15-18 minutes (max) time the agent will think of a way for you to call back (advising you to check with your pc manufacturer, check with your ISP, call microsoft to update your software, etc... non-sense!) they need to do this in order to reach their handling time (agents need to reach 21 to 25 billable calls, and billable calls are "solution provided", "resolved", and "dropped call"). ---- believe me, i was one of them ....

SOURCE: I INSTALLED A TRENDNET ROUTER FOLLOWED ALL

try to return to the manufacturer, cause sometimes a gadgets has a factory defect.... you can return and changes that....

Testimonial: "RETURNED THE ROUTER, WAS DEFECTIVE, BOUGHT ANOTHER, INSTALLED IT, WORKING FINE. THANK U"

drpadmanaban

• 32 Answers
• Posted on Oct 19, 2009

SOURCE: Router setup gets Error 302 message

Old configuration parameters are lost. Check with your service operator for a fresh config details to enable the router in gateway mode.