Had a E90 fault,bosch condenser dryer found if I disconnected pump plug on the pcb mounted rear rhs of machine, rear connector with 2 red wires, fault would not be present and dryer would run, removed pump cleaned, and spun by hand, reassembled and operated correctly
Https://www.searspartsdirect.com/diy/error-codes/dryer-repair/1234594/bosch-dryer/1794
https://appliantology.org/blogs/entry/670-how-to-enter-service-test-diagnostic-mode-in-bosch-wtmc-dryers/
Can't find any E90 code - Bosch's site for E90 just give a contact link to call service.
SOURCE: Error E90
That happened to mine, and apparently it is the connection to the control panal at the front of the machine or the desplay unit (4 blue wires). Take the top off and wiggle them around or re-connect if any are loose. Mine worked for one wash and then started displaying E10........so i'm not amused and I think i may end up getting a hotpoint!
SOURCE: E90 Error Code
an E90 fault is a problem relating to the main control module found behind the front facia. it could just be a bad connection on the board connections though
SOURCE: error code E90
Remove the front panel and on the right side at the bottom youll find the main Circuit board.There is a connector on the harness that needs to be making a tighter contact.Make sure that all the wires that are in contact with the circuit board are firmly touching.Sometimes using a pair if pointed tweezers and a sewing needle will be all you need to fix this .There is hope so dont go out and replace any parts just yet. .
SOURCE: washing machine displaying E90 error
an E90 fault is a problem relating to the main control module found behind the front facia. it could just be a bad connection on the board connections though
SOURCE: bosch dryer error code F11
Sorry to be the bearer of bad news. F11 indicates a fault with the main control board.
17,116 views
Usually answered in minutes!
×