How to Set Up Linksys WRT54G Wireless G Router

SOURCE: Linksys Wireless G Router Model WRT54G

It didn't work for me.
Should the username be the email address from At&t that controls the DSL line, or should it be the username to get into the Netopia modem?

SOURCE: Need to add Linksys WRT54G-TM wireless router with Linksys SPA 2102 phone adapter

your SPA2102-R seems to have one ethernet connection and one internet connection.
your WRT54G-TM seems to have one internet connection and 4 ethernet connections.

What you are trying to achive is; plug a ethernet cable into the ethernet connection on your SPA2102-R then plug the other end into the internet port of the WRT54G-TM

hope this helps, I have assumed that you intend to use a DSL broadband supplier not ADSL.

if you are changing service from DSL to ADSL then your WRT54G-TM needs to be first in line configured and working. then plug the internet port from the SPA2102-R into any of the WRT54G-TM ethernet ports.

SOURCE: Linksys WRT54G wireless router not compatible with Aztech modem?

Darvin, gotta love your ISP. Never fear......

if it isn't too much of a problem (knowing you have wireless setup done already), then do a factory reset on your router ** remember to copy the WEP Key if you have, or recall the PASS PHRASE so you won't have to reset all wireless devices ** Reset is located on back, you need a ball point pen to reach the reset switch.

Reset process: unplug, take ballpoint pen & insert into reset switch & plug unit back in. Sometimes tricky, but you should notice green light goes to yellow/orange upon resetting.

RESET or NOT - you want the Linksys set for ::

Connection Type - AUTOMATIC (for automatic discovery)
Router IP Address - 192.168.2.1

DCHP - ON, Addresses - 192.168.2.100 and allow 5-50 users
(for security, assign the number of DESKTOP + WIRELESS expected users +1, this way you don't get overrun without knowlege)

Take the cable from Aztech ETHERNET OUT to WAN on Linksys. (usually BLUE) (??) not 100% sure as I have the little silver pocket edition of the same Router. - power cycle (turn both DSL modem & Linksys off for 20 seconds. turn on DSL Modem, wait till it's about as ready as possible, turn on Linksys, should only take 20-30 seconds to power up & recognize.

VERIFY SETTINGS: access router - 192.168.2.1, goto STATUS. you should see IP Addressing, SubNet, DNS1 & DNS2 settings. If you do not, then you have no internet connection.

ALTERNATIVE,

Setup Linksys Router with COnnection Type: PPoE, you will need your ISP assigned ID & Password. Follow all other instructions properly.

If you still have problems, please contact me at 906-495-1707 or via Yahoo IM [email protected] or through this website.
once

SOURCE: Wireless webcam behind dsl modem/router and a wireless router

1. Verify that the public router is accepting connections on the 1024, not just forwarding.
2. Verify that the internal linksys router is accepting connections on 1024 too, not just forwarding.
3. Verify the default gateway for the internal linksys router is the public router.
4. Mine works with two routers.

SOURCE: SPEEDSTREAM 4200 MODEM CONNECTED TO WRT54G ROUTER WIRELESS DONT

turn on the wireless option in the router...
plug your computer into the router type in
192.168.1.1
username: admin
Password: public

go to wireless tab
turn it on

END!
P.S.
Also you have to be in range!