Link to some troubleshooting ideas
Like wire connectors are not firmly connected, carry to much load, low battery the link is below
https://www.kidswheels.com/ride-on-toy-troubleshooting-page
https://www.youtube.com/watch?v=EA-XkdxzsGI
SOURCE: I have a Coleman Powermate 5000 / No power output
Two suggestions. One: check for voltage from the secondary coil wires (if it has one). Two: unless stated do not do this, I have always flashed the excitor circuit through the 120vac receptical. Give these a shoot and I hope it works for you.
SOURCE: looking for a replacement battery for a
More than likely go to wallmart by their bike rack and look i used to work there. they are usually over by the powerwheel toys.
SOURCE: UNABLE TO FIND RECHARGING OUTLET ON KIDS RIDING TRACTOR
The peg perego battery for the gator is located under the front behind the black gril.
If you have any additional help I would contact http://www.shopjandl.com/
They always help me with my ride on toys.
SOURCE: I need a replacement circuit board for a pacific
You might not need a circuit board, especially if it has a kid trax or safety 1st battery in it. You can find out more at www.cammhsm.com
I know, I have a vehicle like this and had to find out the hard way.
SOURCE: I have a toshiba 42HL167. Love it but recently
Yes. The Yellow LED blinking 3 times is a normal boot-up, but if it keeps doing it -- it needs the firmware "update" (which is more like a reload because it got corrupted.) The problem is, no one talks about how to do that. (there is a PDF and firmware on toshiba's website, but it lacks some crucial details.)
My friend gave me his 42HL167 after this problem started after a power event during a storm and I managed to fix it by reloading the firmware.
I posted instructions on my website at:
http://www.benjammin.net/www/pages/techtips/Toshiba-Regza-42HL167.html
Once I figured out some of the facts, it was a breeze...
258 views
Usually answered in minutes!
×