Our t.v. remote quit working after working intermitantly --bought a new remote --that doesn't work either --it's not the batteries--what next?

0045,0026,0069,0038,0024. These are the setup codes to check with Emerson TV/VCR combos. If you wish to get more codes and other details, check this link.

\its most likely the ir sensor which has the issue. I will need the model number of your set to help you further on the issue. You can reply to this same post for further assistance if needed.

1) the batteries will be the same type and full charged
2) clean the contacts battery from dirty, dust, oxide or corrosion
3) retight the spring contacts battery with pliers for a GOOD contacts
4) open the remote.control and clean the keypads switch, from dirty, dust, oxide, Open contacts, or Bad contacts. they emite a good signal infrared from SYScon transmi vs Syscon receiver.
see the block diagram. If doesnot resolve the problem go to the repair shop TV for fix it.
God bless you

Yes, they can. Another possibility, however, is the jumper settings could have been accidently changed when the battery was changed. Inside the remote is usally four little switches in a row, each can be on or off (zero or one). These need to be set to the same values as the receivers in the fans.

Check for rusted battery contacts due to leaked batteries. Clean them with polish paper or blade. Due to leaked batteries it is quite likely that the wires connecting remote control pcb & battery contacts are cut off.

sonsunny

there are several things to try.. first, isolate the source of the problem... get a universal remote (borrow one from a friend if you don't have one--get the instructions, too)...then program it for your tv...if the UR doesn't work, then there is a problem with either the tv or its remote sensor...try the troubleshooting guide for the tv or call the customer service line (ask if there are similar probs going around for that model..you might get some special incentive to quit ****, if so..) If it DOES work, then it's your remote...best thing to do is make sure that the batts are good (which you did....but make sure you didn't get a fresh set of batteries from the same bad lot - it happens)...then check to make sure that the connections for the batteries are not missing, broken, or bent.. Look for corrosion, loose wires, solder gone...anything you can see which might cause your problem...Nothing visible? send it back..or try to exchange it at the store you bought it from, if it's a currently selling model Hope that helps you

Sounds like you need a remote, or the remote lost its program. You need to check at the dealership to be sure.

take your remote very close to am radio & press the buttons if there is no reception on the radio, change ur remote

I'm not interested in your services anymore. Thanks!!!

Well I have three suggestions for you. First off I wouldn't recommend including personal information including your full name and address on a place such as this. There are alot of crooks out there. Second, try unplugging the television and taking the batteries out of the remote control at the same time. Leave it like this for atleast 5 minutes and then plug it back in and replace the remote with new batteries. If that doesn't correct the problem, my next suggestion is to buy a new replacement ILO Remote Control, a good site is http://www.remotecontrolscenter.com but there are other sites out there that sell the original replacement remote control. Hopefully this helps solve your problem!