I have a xerox 7750, just installed a new image unit and now i am getting an error message 9-913. HELP PLEASE
This problem occurs when you buy the wrong image unit.
The contact chip that is located at the bottom of the orange plastic is not for the machine. Replace it with 7750 image unit and that should fix your problem. Black is fault 9-910 cyan fault : 9-911 magenta fault: 9-912 yellor 9-913.
In imagining unit search about connector and just replace it with 7750 connector it will fix problem ,for new connector you can ask your tech-nation or contact me
[email protected]
The problem come from the electronic part of the image unit. It can be easily replaced by customized part. It can be easily buy on ebay.
Hi sorrosmum:
I can not find the error 9-913 in the service manual so i am giving you this info to try. Hope this helps.
1 1. Replace the imaging unit reporting the
error.
2. Does the error still appear?
Go to step 2. Complete.
2 1. Remove the imaging unit from the
problem location and inspect the
connector.
2. Is the connector damaged?
Replace the
imaging unit plate
assembly.
Troubleshoot the
wiring. If wiring is
OK, replace the
engine control
board.
SOURCE: Phaser Imaging Unit install error
Worked like a charm! Thank you for the detailed information. The step by step instructions were right on target.
SOURCE: I keep getting Error code
That is the fuser fan. It is either running slow or stalled.
You have to remove the rear and top cover to access it. It is located on the upper right back side of the machine looking from the rear.
You can remove the fan, peel off the silver label then remove the small rubber cap in the middle. Behind that rubber cap is the fan bearing, It is dirty and needs to be cleaned.
You can flush it with alcohol then add a highly refined oil to that bearing, Replace the rubber cap and then clean the outside with alcohol, then put a small piece of tape over the rubber cap to keep it in place. Most of the time. I would say 75 % of the time that will fix the problem. If it doesn't fix it in the long term you wol have to replace the fan. Don't call Xerox directly, Go onto google and look up a business called " the parts drop". Call them and ask for Britt or Joe> I dont work for them, but have purchased parts from them for years. They are reliable, fairly priced and honest. Great people to do business with.
SOURCE: hi i got xerox phaser 7750 and i have error code
Cheap fix : reset the Developer Life Count in the Service
Tools menu. Hold down the back ARROW key with the "i" them with your other hand turn on the machine.
Expensive fix : What has happen is that the developers have come to the end of the life and once it gets to a certain page count it will print out no more until you have replace the developers. One thing xerox forgot to do is reset the engine control board too for this machine. So you might need a new engine cotrol board too.
Procedure
1. Replace the Developer
2. After the Developer has been replaced, reset the Developer Life Count in the Service
Tools menu.
NOTE: It is recommended that all the Developers and Beads be replaced at one time rather
than on sccessive visits.
Good luck.
2,199 views
Usually answered in minutes!
×