When stiching on my janome - my excel 23l the bottom thread tangeled...i changed the needle and re threaded the bobbin...now the bobbin wont feed through...i also fiddled with the tension which I have on 4 and a black knob on the top left hand side of the machine under the flip cover which i fiddled and don't know where that should be.It has a 2 and 3....please help ....
Take the bobbin out check for debris (pieces of thread, lint, etc.) that may be jamming the bobbin. check under the feed plate for a thread jam or debris. check if your bobbin is wound too tightly. it can happen! then it will keep breaking. the other adjustments are mainly for thread tension- the spool on top. if they're too tight, the thread will keep breaking. you can tell- once they're properly adjusted- by the quality of the stitch. check the bobbin first! if it's too tightly wound, you can probably adjust the winding tension on top. try a different bobbin. if that works then 'rinse and repeat!'.
good luck!
Testimonial: "thanku.The prob was the needle was incorrectly inserted & after adjustment the bobbin fead.the prob is the needle inserter moves 2 much,any ideas plz"
325 views
Usually answered in minutes!
×