I'm getting a code "LE".

check pump for blockages

Error code 3 indicate that the control board and the motor are either not communicating.

fault with the programe as it has stoped in mid cycle

Any error codes?

EE
Remove your washer from the power source if you see an "EE" error code, where the first E is missing the top part of the letter. Your washing machine has a serious malfunction, and you must contact a technician.

A bit odd that as error code EE does not exist for washing machines, it's a refrigeration error code. Unless of course part of the display (led) has been damaged and the code isn't displayed properly.

Hope helps.

The 'LE' error message indicates the control board has detected that the motor is either not turning, or has locked up for some reason. Monitoring the motor is the job of the hall effect sensor board which constantly determines the direction and speed of the motor and feeds that information back to the control board. If there is a problem between what the motor should be doing and what the hall effect sensor says the motor is doing, the 'LE' will be displayed and the cycle will be stopped.
Motor lock can be caused by several things from a loose connector, to a bad motor, or even the hall effect sensor failing or dislodging from it's mount. Any one or more of these components could have caused this error.
This error can sometimes present because of a miscommunication between the control panel and the wash motor. In this instance, the washer simply needs to be reset.

Step 1: Unplug the washing machine.

Step 2: While the washer remains unplugged, press and hold the [Start/Pause] button on the front panel for 5 seconds.

Step 3: Plug the unit back in, and run a rinse and spin cycle to test if the LE code is cleared.

Hi from retired Englishman in SW France,
'le' stands for Lock Error. There is likely to be a problem with either the door solenoid/lock or the 'door closed' sensor. Both require a service engineer's attention I suggest ;-0(
Good luck,
John C

Hi,
Sensor maybe???

Here is a tip about the LE code that gives other thoughts also...

heatman101

FH, in mid cycle most likely your pump is blocked, hit drain/spin and see if water drains, if not clean pump

Suggestion: Your wash could be overloaded; put in clothes within machine's capacity. What is written in your manual's max clothes capacity. If your heater is on; switch off machine and wall plug. Reset the machine with the heater on minimum & resume your normal cycle.