I have a whirlpool adp951 with a green light flashing

Please recheck how many times it is flashing. It can be as many times as 13 flashes to be an error message. Try this webpage as a guide to what it could be.

https://www.espares.co.uk/advice/careandmaintenance/whirlpool-dishwasher-error-fault-codes

Dishwasher is in fault mode hold start/pause button for a few seconds this will reset the unit run your cycle again if dishwasher faults again call you local service man.good luck

Anyone got an answer to this, as I have exactly the same fault.

Dishwasher appears to switch on OK, then after a short time (20 secs?) the pump noise stops and the green light flashes - it seems to e a sequence of 7 flashes, then stop... 7 flashed then stop.

The sequence could indicate a fault detected?

Anyone know anything about these units from IKEA, made by Whirlpool?

Thanks!

S

HI,

This is an indication that the water did not heat properly. I have put together some instructions on what can cause this and how to reset the control so you can use the dishwasher again. Follow the link below and let me know if this helps.

http://www.fixya.com/support/r4628906-flashing_or_blinking_green_clean_light_7

My advice, go buy a new one. If money is tight, go to the clearance aisle at Home depot and look for a scratch/dent discount model to replace it.

Old dishwashers were never good from the beginning. No point in fixing it - it was never designed well.

Pour white vinegar into the rinse cycle, this should help.

The dishwasher will not start. The following things have occurred;
1. The Cycle option light is flashing.

The model is GU2500XTPS3



Can anyone please assist if they have seen this problem before?

Have a look underneath dishwasher by removing front bottom access panel, the one touching the floor. Look for a round plastic disc about size of 4 jam lids together, centre front of dishwasher. Inside of it is a foam disc that will float up off the base of the dishwasher if water causes it to do so. This floating up will trip a switch. Clean base of dishwasher of water and maybe test the switch with multimeter. Reset fault by holding down start button.

try holding down the on button for three seconds and sometimes it will complete the cycle. ours doesn't start the whole time. check your water regulator valve under your sink, as it may be leaking which may cause the problem, in the process of replacing mine, but can't find the psi value

Processor board sound bad. May be a loose plug ( or corroded connection on the plug ) . Unplug the dish washer from the wall plug before servicing. The open the front panel to expose the panel control board. Unplug the panel plugs and inspect them to assure no corrotion is apparent. If you see corrotion, use a pencil erracer to clean all contact points on the board and clean the plug the best possible. Plug the dishwasher plug back in the wall and check the unit for proper operation. If the operation is not correct, replace the circuit board. I hope this helps
Ed
NC Electronic
Mills, Wyoming