My Maytag Atlantis washer keeps intermittently filling with water, whether the load is going or even when the machine is on the ''off'' position. Each fill is about a minute apart, and lasts about 7 seconds. I replaced the inlet valve, and checked the pressure switch/tube, and they seem fine. The water does not keep filling until it overflows... it just fills on and off until it reaches the point of a normal wash load, then stops. When I unplug the machine it stops. Any ideas?

john gagnon

• 943 Answers
• Posted on Sep 17, 2008

SOURCE: Maytag Atlantis MAV6451 Waterfill keeps filling

hi todd it looks to me that the problem with the water level control or the small level control hose hard water &lint can sometimes clogg this hoe up remove hose from switch and blow into it hard if its clogged you will not be able to blow clean it and try if it does not work after its clean replace water level switch thanks the appliance doc

SOURCE: Maytag Atlantis Washing Machine always runs warm water.

Sounds like it may be a faulty temperature selector switch

SOURCE: Maytag Atlantis MAV7600AWQ Washer. Delayed fill

ALL WASHERS COME WITH SCREENS AT THE
WATER CONNECTIONS.DISCONNECT THE HOSES AFTER TURNING OFF THE WATER.THEN,CHECK THE SCREENS FOR MINERAL BUILDUP.CLEAN THE SCREENS IF
NEEDED AND GO FROM THERE.

SOURCE: Maytag Atlantis screeches @ end of spin cycle,

may be something stuck in the drum or a segment raised on the motor. to test either remove the belt and spin the drum if no noise then the motor is faulty. if a noise then there may be a bra wire between the drum/tub.

SOURCE: Maytag Atlantis won't agitate

possible bad control board.