Samsung refrigerator - frost on outside of freezer drawers

for frost to start appearing in a bottom freezer, indicates that the draw seal is not sealing properly or the draw is not closing fully
after 3 years it may need an adjustment of the rollers and slides to get the draw sealing better again
call in a service technician as it should be still under warranty

sounds like a bad defrost terminator

Hello, Make sure there is no leak at the door gasket! This is the most common reason for this type of frost in the freezer on drawer and racks. Make sure the gasket is sitting flat and not damaged.

Hello:

Most likely your door is not closing properly.. The only moisture you can get inside( frost build up)is from outside. I suggest completely defrosting your freezer and examine door mechanism and make sure its closing/sealing properly..( make sure you check your door gasket for any warps or kinks)

Good luck

3M spray silicone lubricant in 24 oz cans is good down to -23 degrees and FDA approved for being around food. Works a treat.

If the door has a gap, certainly ice build up will occur on the evaporators and block the air flow which will just accumulate more and more if you don't defrost it first. make sure the doors always shut.

Check for door gasket,for leaks.

this could be that your gaket may be sucking in air.check gasket dollar bill trick.put dollar half way in freezer and pull it out.if it pulls out easy your gasket isnt sealing.be sure to go all around the freezer gasket with the bill.

DEPENDING HOW OLD THE UNIT IS YOU MIGHT HAVE A BREAK DOWN IN THE INSALLATION ON THE SIDE WALLS OF THE APPLIANCE.ALSO CHECK THAT THE DOOR SEALS ARE SEALING OK IF ITS A BREAKDOWN WITH THE INSALLATION THAT MIGHT BE A COSTLY REPAIR BUT GET A TECH TO GIVE ADVISE.GOODLUCK.MOHAMED

look on the back wall of the freezer is there snow? if so you have a defrost component out (timer, limit, or heater) the fresh food compartment gets cool air from the freezer so check for blocked air pathways the build up of frost in the freezer stops air flow so you will be cold on freezer side and warm on ref side